Bodet BTX6015 User manual

1
ZI de Martigny
37210 Parçay Meslay
Tél. [phone]
Fax [phone]
www.bodet-sport.com
Ref. 607638B
Upon receipt, always check the product for damage during shipment.
If any is found, you may le a damage claim with the carrier.
GOAL Indicator
for ice hockey
Installation and operation instructions

2
Table of content
I - Checking the supplied equipment .................................................................................................3
II - Overview of the product ................................................................................................................3
III - Wall mounting ...............................................................................................................................4
IV - Clamp mounting.............................................................................................................................4
V - Electrical connections ....................................................................................................................5
VI - Dip switches setting .......................................................................................................................5
Electrical and mechanical safety standards
- Installation and maintenance of this equipment should only be carried out by qualied and authorized personnel.
- Since BT6000 scoreboards are connected to a 110/240VAC supply, they must be installed in compliance with standard IEC 364.
- Indoor use (protected against mechanical shocks according to DIN18032.3 Standard).
- The 110/240VAC supply line for the shot clock panel must include a neutral/phase circuit breaker, rapidly accessible. This circuit
breaker must be switched off during maintenance operations.
- The installation must be completed before the equipment can be powered up.
- It is prohibited and dangerous to immerse the scoreboard in to water or clean it with a water jet.
- Installation ground connection as per EE or EN (earth/earth or earth/neutral) power supply diagram.
- Bodet shall not be held responsible for any use not in compliance with these instructions.
- Any modication to the product shall void the warranty.

3
I - Checking the supplied equipment
The pack is made of the goal indicator panel + the power cord + the Start/Stop handheld push button.
Note:
The power cord supplies the power to the panel.
The handheld Start/Stop push button turns on a GOAL Led indicator (1 indicator per impulse).
II - Overview of the product.
Red Led GOAL indicators
Green Led Clock stopped indicators
Mounting clamps
Power cord
Handheld Start/Stop
push button
Goal indicator panel

4
330
168
Mounting clamps
III - Wall mounting
1/ Install 4 x Ø6mm screws and matching plugs on the wall and slide the panel over the 4 screws.
(The screws and plugs are not supplied by Bodet).
IV - Clamp mounting
1/ Place the panel on its support.
2/ Secure the panel in its position by tightening the 2 clamps with the hand knob screws.

5
V - Electrical connections
1/ Plug in the panel power cord to the 240V/110V power outlet.
2/ Connect the “goal lights module” to the Bodet ice hockey main scoreboard (RS485 communication)
This connection will allow the “goal lights module” to synchronise itself with the scoreboard in
order to display the game clock stopped.
GOAL
TIME
Power cord
Goal indicator panel
To main scoreboard
panel card and “goal
lights module”
Terminal block
of the main scoreboard.
RS485

6
VI - Dip switches setting
1st dip bank
  Onthe1stdipbank,dips1to4areusedforthefactorycongurationofthepanel.
Out of the factory the dips are set as follow:
Dip 1 Dip 2 Dip 3 Dip4
on↑ on↑ on↑ off↓
Dips 5 to 7 are used to identify each panel (If several panels are used on the same site
each panel must have its own number).
Dip 8 is to ON ↑by default.
2nd dip bank (wireless HF only)
Dips 1 to 3 are used to set the installation number.
Dips 4 to 8 are unused. (to OFF ↓by default).
2nd dip bank (wired mode)
Dips 1 to 8 are used OFF ↓.
1st dip bank 2nd dip bank
Panel number Dip 5 Dip 6 Dip 7
1off↓ on↑ on↑
2on↑ off↓ on↑
3off↓ off↓ on↑
4on↑ on↑ off↓
5off↓ on↑ off↓
6on↑ off↓ off↓
N° installation Dip 1 Dip 2 Dip 3
1off↓ on↑ on↑
2on↑ off↓ on↑
3off↓ off↓ on↑
4on↑ on↑ off↓
5off↓ on↑ off↓
6on↑ off↓ off↓