BOMANN KG 7331 Setup guide

1
BOMANN General repair instructions for refrigerators/freezers
You will find general information on the replacement of certain spare parts. The illustrations and repair
or replacement instructions depend on the type of appliance and may differ slightly from the original
appliance.
Liability for damage is excluded if the repair instructions are not followed correctly.
WARNING!
During repair/maintenance work, the appliance must NOT be connected to the mains
power!
Replacing the door seal
 Remove the contents of the appliance and, if
necessary, defrost the appliance. Pay
attention to how the old seal is fixed. Most
gaskets are only plugged in or fixed by small
screws.
 Remove the worn gasket rubber by either
removing it from the plug-in device or
loosening the screws. Carefully clean the
appliance door and the groove below the
rubber and remove any adhesive residue.
 Depending on how the old sealing rubber was
attached, attach the new rubber. If necessary,
heat the sealing rubber with a hair dryer or hot
water and shape it by hand. Start pressing the
gasket in one corner and then press it all
around the door into the provided socket.
 According to the type of appliance, refasten
the screws or plug-in positions on the
appliance.
 Continue to check the door seal regularly for
dirt and damage!
Replacing the door handle
 Loosen the screw cover caps.
 Unscrew the screws.
 Remove the door handle.
 Door handle assembly is performed in reverse
order.
Replacing the door hinges
 Remove the contents of the appliance and the
interior fittings.
 Tilt the appliance backwards and block it in
this position to prevent the appliance doors
from sliding out.

2
Replacing the upper door hinge
 Depending on the type of appliance, first
loosen and remove the appliance or hinge
cover.
 Disassemble the
upper door hinge by
loosening the
screws.
 Door hinge assembly is performed in reverse
order.
Replacing the middle door hinge
 First disassemble the upper door hinge
"Replacing the upper door hinge".
 Remove the upper appliance door and place
the door safely aside.
 Disassemble the
middle door hinge
by loosening the
screws.
 Door hinge assembly is performed in reverse
order.
Replacing the lower door hinge
 Depending on the appliance type, first
unscrew the stand foot.
 Disassemble the
lower door hinge by
loosening the
screws.
 Door hinge assembly is performed in reverse
order.
Replacing the shelves/drawers
Depending on the appliance type and equipment,
the various shelves and drawers can be removed
and replaced.
Replacing the glass/bottle shelf
 If necessary, lift the shelf, slant slightly and
pull it out to the front.
 Safely slide/insert the shelf in reverse order.
Replacing the door shelf
 Lift the door shelf until it releases from the
retainer and remove it.
 Place the door shelf flat, press down both
sides of the shelf at the same time so that it
locks into the retainer.
Replacing the drawers
 Remove the drawer to the front, incline it if
necessary and remove it (Fig. 1).
 For a drawer that can be pulled out on
telescopic rails, first pull it out completely and
remove it to the top (Fig. 2).
 Insert the drawer, if necessary, lift the front
part of the drawer slightly and push it in
completely. Make sure that the drawer is fitted
into the guide rails.

3
C. Bomann GmbH
www.bomann-germany.de
Stand 07/2022