Bose Noise-Masking Sleepbuds User manual

(A) Lift and remove the rubber
pad from the back of the
charging case.
Noise-Masking Sleepbuds™-
charging case
(B) Cut wires in this order:
1) Red -Positive (+)
2) Black -Negative (-)
3) White
As each wire is cut,
place electrical tape over each
wire end as shown in (C) below.
Carefully remove the battery which is held in place by double-sided tape.
1
3
2
(C) Removed battery shown.
Dispose of the soft pack lithium-ion battery and the remainder of the product in
accordance with local regulations.
Soft pack
lithium-ion
battery
Soft pack
lithium-ion
battery location
1 2
3 4
Locate and remove the
four screws.
Note the soft pack
lithium-ion battery
location.
Avoid damaging the
battery while opening
the charging case.
Soft pack lithium-ion
battery

(A) Product is a sealed assembly.
Carefully remove the plastic
top-cap from each earbud as
represented in the figures to the
right.
Note the coin-cell silver-zinc
battery location. Avoid
damaging the battery while
opening the product.
(C) Removed battery shown.
Dispose of the coin-cell silver-zinc
battery and the remainder of the
product in accordance with local
regulations.
Noise-Masking Sleepbuds™-
earbuds
(B) Carefully clip the terminals connecting
the battery.
Place electrical tape over each
battery terminal as shown in (C) below.
Coin-cell silver-zinc
battery location
Coin-cell silver-zinc
battery
1st terminal to
be clipped
2nd terminal to
be clipped