Box Scientific Heliport User manual
Product Manual
Heliport
Thaw Station
with Integrated
600W Heating System
Becnhtop Installation
Your Heli port Thaw Station is now ready for benchtop use!
1 Heli port Thaw Station
1 220VAC Power Cable
11 Microplate cradles
1 6 ft remote I/O cable
1 Restrictor plate
Contents
- Heli port has two operational modes: Remote Power and Direct
Power.
- Power on the unit by fli pping the 3-way switch towards the
rear of the unit for Direct Power.
- Power on the unit for remote I/O control by fli pping the 3-way
switch towards the front of the unit for Remote Power.
- In Direct Power mode Heli port will run continuously until powered
off (center switch position).
- In Remote Power mode Heli port can be toggled on or off using
software controls for the selected remote port.
Operation
- Remove contents from foam packaging.
- Plug the female end of the power cable into the receptacle
on the left side of the unit.
- Connect the power plug to a 220VAC electrical outlet.
- Position unit with logo side facing out.
- Leave at least 6 inches between the rear of the unit and
walls or other obstructions.
- Position plate cradles in any desired portrait or landscape
configuration.
6 in from wall 220VAC
Robotic Workstation Installation
- Install Heli port in any available space on your workstation deck as
described in Benchtop Installation.
- Position Heli port as required for access to robotic manipulators.
- Connect the remote access cable to the remote port next to the
power switch.
- Connect the remote cable to any 3 pin port with the following
(L-R) pinout:
- Blank / +24V / -24V
- Position plate cradles onto top surface as desired for matrixing to
automated scri pts.
-Heli port is now ready for remote operation!
Heated Mode
-Heli port features a heating system that can supply additional heat
for larger jobs or samples with high melt points.
- The heating system is self-thermostatting and will maintain a
steady current of 90F air at the thawing surface.
-As a safety precaution the heating system can only be operated
with the fans running.
- Heated mode requires the use of the included restrictor plate to
create the optimum delivery of properly warmed air.
- Install the restrictor plate so that the pins along its longest edge
mount to the last row of holes on the thawing surface.
-Configure the remaining thawing surface as needed.
-Power on the heating system by moving the switch labled “Heater”
to the on position.
-Allow roughly 1-2 minutes for the heaters to reach operating
temperature.
- The heating system can be powered down by switching the
Heater power switch to the off position or by switching off the unit’s
main power.
Box Scientific
2805 Rosewood Ln.
Newton, NC 28658
(408) 361-8631
www.boxscientific.com
Full One Year Warranty
Terms and Conditions
Table of contents
