Brabantia D10-1 User manual

2
www.brabantia.com/electrical-appliances
BRABANTIA
TABLE
BLENDER
Instruction Manual
D10-1

2
THANK YOU FOR
PURCHASING OUR
TABLE BLENDER
We hope it will delight you and that it
will get a special place in your home.
Enjoy!

3
IMPORTANT SAFEGUARDS
Please read the following instructions carefully before using the appliance.
1. This appliance is only for domestic use, and not for commercial use.
2. Always disconnect the appliance from the supply if it is left unattended
and before assembling, disassembling or cleaning.
3. Do not allow children to use the appliance without supervision. Keep
the appliance and its cord out of reach of children.
4. Inspect the power cable and appliance regularly. If any defect is found, do not operate.
5. Do not attempt to repair the unit yourself, it must be repaired
by qualified technicians to avoid any hazard.
6. If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or a qualified person in order to avoid a hazard.
7. Keep appliance and cable away from direct radiant heat from the
sun, from damp, from sharp edges and other dangers
8. Never leave the appliance unattended connected to the mains! Always pull the plug out of
the socket when you do not use the appliance, even if it is only for a brief moment.
9. Never use any accessories or parts from other manufacturers.
10. Do not use outdoors.
11. Never immerse the unit in water or any other liquids, or come into
contact with them. Do not use it with wet hands.
12. If the appliance should become wet or damp, remove plug from mains
socket immediately. Do not put your hands in the water!
13. Use this appliance only for its intended purpose.
14. Never touch the rotating tools while still in motion; always wait for them to stop.
15. To reduce the risk of injury, never place cutter-assembly blades on base without jar properly attached.
16. The appliance is not be used by children or person with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction. Children should be supervised to ensure that they do not play with the appliance.
17. CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cut-
out, this appliance must not be supplied through an external switching device, such as a
timer, or connected to a circuit that is regularly switched on and off by the utility.
18. Care should be taken when handling the sharp cutting blades, emptying the jug and during cleaning.
19. When mixing hot liquid or food, excess pressure may build up inside the blender and this
may cause the lid to come off and the contents to splash out. Avoid mixing excessively
hot food and only place small quantities of hot liquid or food inside the blender.
20. Do not use the blender for very hard food products such as bones, shelled nuts,
frozen meat etc., as this may damage the blade or cause the motor to seize.
21. The blades of the jug are very sharp. Never touch the inside of the jug
or place any objects in the jug while the blades are turning.
22. Avoid potential injury through misuse.
23. Take care when handling the sharp blades, when emptying
the glass jug and during the cleaning process.
24. All repairs may only be carried out by an authorised service centre.
Improper repairs may place the user at risk.
25. When handing this product over to a third party, ensure that this
instruction manual is supplied with the appliance.

4
PARTS DESCRIPTION
A. Measuring Cup
B. Lockable lid
C. Glass Jar with safety
locking system
D. Blade assembly unit
E. Main unit
F. Knob
A
B
C
E
F
D

5
DOUBLE SAFETY LOCKING SYSTEM
This system ensures user can only switch the appliance on when the lid has been placed
and locked on the unit in correct position. When the accessories have been fixed properly,
the unit can only be switched on. (i.e. Safety locking system is disabled at this moment)
BEFORE FIRST USE
Clean the units and parts thoroughly before you use the appliance for the first time.
The blades are very sharp. Wash with care.
Never touch the blade with your finger.
HOW TO USE YOUR TABLE BLENDER
1. Screw the blade assembly unit to the glass jar bottom until it is fixed properly.
2. Place the glass jar with blade assembly unit interface on the motor unit.
3. Place the lid on the jar and lock onto the handle.
4. Insert the measuring cup into the lid opening
5. Connect to main power supply.
6. Select the speed by turning the knob.
Note: Do not let the appliance to operate more than 3 minutes continuously. Let the
appliance to cool down to room temperature before continue operating the appliance.
AFTER USING THE TABLE BLENDER
1. Disconnect the power from main supply.
2. Remove the lid (together with measuring cup) from the jar.
3. Remove the jar (together with blade assembly unit interface) from the motor part.
4. Detach the blade assembly unit interface from the bottom of the jar
Note: It is recommended to cut the food into smaller pieces before putting
them in the jar. Do not operate with large quantities of food at one time.

6
TIPS OF USING YOUR BLENDER
1. Do not blend dry, thick or heavy mixtures for more than 10 seconds continuously. Let the
appliance cool down to room temperature before continue operating the appliance again.
2. Crush Ice, not more than 2 seconds continuously for each pulse operation.
3. Do not place the lid into a dishwasher or boiling water, the lid may deform.
4. Always hold the edge of the lid while operating the blender.
After every max operation period, please let the appliance cool down to
room temperature before continue operating the appliance again.
CLEANING AND MAINTENANCE
Disassembling and cleaning the Table Blender
1. Put the stainless steel power base on a flat, dry surface. Ensure that the speed
selector knob is in the off position and that the power cord is unplugged.
2. Hold the power base with one hand and with the other hand pull the
glass jug handle up to remove the glass jug and blade mechanism.
3. To enhance the life of the product hand wash in hot soapy water.
Caution! The blades inside the glass jug are very sharp.
SPECIFICATIONS
Model: D10-1
Rating: AC 220V-240V 50-60Hz
Power input: 600W

7
ENVIRONMENT FRIENDLY DISPOSAL
Correct Disposal of this product (Waste Electrical & Electronic Equipment)
(Applicable in the European Union and other European countries with separate collection systems) The
European Directive 2012/19/UE on Waste Facilities Electrical and Electronic (WEEE) This marking shown
on the product or its literature, indicates that it should not be disposed with other household wastes at the end of
its working life. To prevent possible harm to the environment or human health from uncontrolled waste disposal,
please separate this from other types of wastes and recycle it responsibly to promote the sustainable reuse of
material resources. Household users should contact either the retailer where they purchased this product or their
local authority office, for details of where and how they can take this item for environmentally safe recycling.
ENVIRONMENT FRIENDLY DISPOSAL
Correct Disposal of this product (Waste Electrical & Electronic Equipment)
(Applicable in the European Union and other European countries with separate collection systems) The
European Directive 2012/19/UE on Waste Facilities Electrical and Electronic (WEEE) This marking shown
on the product or its literature, indicates that it should not be disposed with other household wastes at the end of
its working life. To prevent possible harm to the environment or human health from uncontrolled waste disposal,
please separate this from other types of wastes and recycle it responsibly to promote the sustainable reuse of
material resources. Household users should contact either the retailer where they purchased this product or their
local authority office, for details of where and how they can take this item for environmentally safe recycling.
WARRANTY
The warranty will only be valid if the product is returned with proof of purchase and original packaging.
Warranty Policy
Our goods come with guarantees that cannot be excluded under the Australian
Consumer Law. You are entitled to a replacement or refund for a major failure and
for compensation for any other reasonably foreseeable loss or damage.
You are also entitled to have the goods repaired or replaced if the goods fail
to be of acceptable quality and not amount to a major failure.
The distributor for Brabantia products in Australia, Sheldon and Hammond Pty Ltd, guarantees
this product for domestic use only. No warranty is provided for commercial use.
Sheldon and Hammond do not provide warranty for items bought from overseas retailers or from parallel importers.
For all enquiries, please contact Sheldon and Hammond Pty Ltd on our toll free number 1800 808 971.
The warranty will not be valid if:
1. The product has not been installed, operated or maintained in accordance with
the manufacturer’s operating instructions provided with the product.
2. The product has been used for any purpose other than its intended function.
3. The damage or malfunction of the product is caused by any of the following:
• Incorrect voltage
• Accidents (including liquid or moisture damage)
• Misuse or abuse of the product
• Faulty or improper installation
• Mains supply problems, including power spikes or lightning damage
• Infestation by insects
• Tampering or modification of the product by persons other than authorised
service personnel
• Exposure to abnormally corrosive materials
• Insertion of foreign objects into the unit
• Usage with accessories not pre-approved by Brabantia
Please refer to and heed all warnings and precautions in this Instruction Manual.
Due to continuous product development, specifications may
be subject to change without prior notification.

Manufactured by SRB Pacific Limited under
exclusive licence of Brabantia Nederland B.V.
SRB Pacific Limited,
PO Box 113068, Newmarket,
Auckland 1149, New Zealand
PRODUCT INFORMATION
D10-1 TABLE BLENDER