Braum BRHB-50BM User manual

This harness bar is sold without warranty expressed or implied. No warranty or representation is made as to this product’s ability to
protect the user from possible injury or even death. The effectiveness, warranty and longevity of this equipment are directly related to
the manner in which it is installed,used, and/or maintained. THE USER ASSUMES ALL RISK.
Tools needed/used:
17mm wrench, 14mm wrench, 3/8's Ratchet, 3/8's T50 torx head, 8mm allen wrench.
[BRHB-50BM & BRHB-50RG & BRHB-50WG]
17mm wrench
14mm wrench
3/8's Ratchet
3/8's T50 torx head
8mm allen wrench
2010-2015 Chevy Camaro Harness Bar
[e-mail] - [phone]

Step One: Locate the top and bottom ends of the OEM seatbelts.
2
Step Two: Lift up on the bottom of the top seatbelt end to reveal the T50 torx bolt. Using your 3/8's ratchet
and T50 torx end, remove the top and bottom bolts of the seatbelt ends. Save the bolts for they will be
reused.
[e-mail] - [phone]

Step Three: Slide the top bracket of the harness bar behind the OEM seatbelt and bolt into place using
the original T50 torx bolt. Leave slightly loose to adjust later. Repeat for opposite side.
Step Four: Using the supplied "L" bracket, insert the cylinder end into the bottom seatbelt end hole with
the "L" towards the rear of the vehicle.Bolt the OEM seatbelt end using the original T50 torx bolt.
Do not tighten for later adjustment.
[e-mail] - [phone]

Step Five: Using the supplied gold spacer and 8mm allen bolt, attach one end of the harness support bars to
the harness bar. Attach the other end to the back of the "L" bracket using the supplied washer nuts and allen
bolts. Use the 14mm wrench to help tighten. Adjust bars as needed to properly bolt into place.
[e-mail] - [phone]

Step Six: Using the 17mm wrench, tighten all ends of the harness support bars once no other adjustment
is needed. Straighten and tighten all other bolts left loose in earlier steps.
Step Seven: Clean up and enjoy your beautifully finished product installation.
If you have any installation questions, please contact us at 213-550-3295 or [e-mail]
5