Braun SWING B 1200 User manual

B 1200 •BC1400
swing
Type 3517
Type 3519
s
w
i
n
g
1
4
0
0
www.braun.com/register
98907530/I-09
China/GB
98907530_BC1400 China/GB Seite 4 Dienstag, 20. Januar 2009 10:57 10

1
2
3
4
s
w
i
n
g
1
4
0
0
98907530_BC1400 China/GB Seite 1 Dienstag, 20. Januar 2009 10:57 10

98907530_BC1400 China/GB Seite 2 Dienstag, 20. Januar 2009 10:57 10

English
Carefully read the use instructions
before use.
Important
•
Plug your hairdryer into an
alternating current ( Ù ) outlet only
and be sure that your household
voltage corresponds to the
voltage marked on the hairdryer.
•
This appliance must never
be used near water (e.g. a
filled wash basin, bathtub
or shower). Do not allow
the appliance to become
wet.
•
When using the hairdryer in
a bathroom, always unplug it
after use. Even a switched-off
hairdryer presents a hazard
if not unplugged.
•
For additional protection, it is
advisable to install a residual
current device (RCD) with a
rated residual operating current
not exceeding 30 mA in the
electrical circuit of your bath-
room. Ask your installer for
advice.
•
Care should be taken not to
block the inlet and outlet grill
when the hairdryer is switched
on. If either grill becomes
blocked, the hairdryer will auto-
matically cut out. After cooling
for a few minutes, it will switch
back on automatically.
•
Do not wrap the mains cord
around the appliance. Regularly
check the mains cord for wear or
damage, particularly where it
enters the product and the plug.
If you have any doubt about its
condition take the appliance to
your nearest Braun Service
Centre for checking/repair.
The mains cord of the appliance
may only be replaced by an
authorised Braun Service
Centre. Unqualified repair work
can lead to extreme hazards for
the user.
Switch 1
0 = off
1 = gentle drying
2 = fast drying
Cold shot
(BC 1400 only)
To fix a style, shortly activate the
cold shot button 3 .
Power Flower nozzle 4 :
For extra fast and gently drying
with the Power Flower nozzle,
use the hairdryer with the highest
switch setting.
Easy-to-clean filter
Regularly wipe the filter 2 clean.
For a thorough cleaning, remove
the filter and clean it under running
water.
Subject to change without notice.
This product conforms to
the European Directives
EMC 2004/108/EC and Low
Voltage 2006/95/EC.
Please do not dispose of the
product in the household
waste at the end of its useful
life. Disposal can take place
at a Braun Service Centre or at
appropriate collection points
provided in your country.
98907530_BC1400 China/GB Seite 3 Dienstag, 20. Januar 2009 10:57 10