Breatheaudio Ba-650rk-gt User manual

Introduction

Congratulations on your purchase of the BreatheAudio garden rock speakers. Enjoying high quality sound outside is no longer a lifestyle for the rich and

famous. The BreatheAudio rock speakers offer a very affordable, and attractive highlight for any garden or patio area. While enjoying the outdoors, you can

delight in your favorite music or just relax and listen to the game. What ever your preference, the BreatheAudio rock speakers will provide years of outdoor

music enjoyment.

Proper Placement of Your Rock Speakers

Ideally the speakers should be placed on either side of the targeted listening area with about 8 to 10 feet of separation. This will allow the best enjoyment of

stereo audio. The speaker design allows them to be placed on the ground among garden plantings. Be careful when concealing the speakers not to cover the

grill area with any substance or plantings that could impede the sound. Try to leave 5 to 7 feet distance between the speakers and the listening area.

Making the Connection

Do Not Use electrical or duct tape as a means of weatherproofing the wire

connection.

The speakers are easily connected to any audio amplifier using the sealed speaker wire pigtail from the back of the speaker enclosure. The red lead indicates

the positive signal and black indicates the negative signal. These should be spliced with the corresponding wire coming from the source amplifier. Note that

most speaker wire indicates the positive with a red wire and the negative signal with a black wire. Some wires indicate the positive lead with a dark stripe on

the wire or in many outdoor low-voltage wires the negative lead is indicated with a rib in the insulation. Connecting the positive and negative leads incorrectly

will cause it to be out of phase and will result in a weak bass response.

Remove 2 to 3 inches of the outer jacket of the speaker wire coming from the source amplifier. Carefully strip about ½ inch of the insulation covering the two

speaker conductors within the outer jacket. Twist the bare speaker wire leads together and screw a wire nut to each of the connected leads.

You should only use wire nuts rated for outdoor weatherproof use.

As an additional weatherproofing option you may want to fill the bottom edge of the wire nuts with a silicone-based sealant. If you are burying

the wire underground, only use speaker wire rated for in ground use. An alternative to burying the wire is to run it through PVC pipe that is buried. Be sureto

seal all joints in the pipe to insure a waterproof enclosure.

BA-650RK-GT and BA-650RK-SA Rock Speaker

Installation Guide

BA-650RK-GT and BA-650RK-SA Rock Speaker Secifications

Description: 6.5” Outdoor Landscape Rock Speaker WOOFER

Power Rating: 70W Magnet: 50z/70x32x10mm/Y3050z/70x32x10mm/Y30

Impedance: 8Ohm Voice Coil: 1.0” Kapton 1.0” Kapton

Efficiency: 89 dB 1W/1M Cone: Mica Filled Polypropylene Mica Filled Polypropylene

Frequency Response: 80Hz-20kHz Surround: Butyl Rubber Butyl Rubber

Tweeter Crossover: 6 dB Octave; ?kHz Dust Cover: Mylar Mylar

Woofer Crossover: None TWEETER

Dimensions (HxWxD): 9 ½ H x 10 ½ W x 9 ½ D (241 H x 267 W x 241D mm) Magnet: Neodymium Neodymium

Cutout Dimensions: N/A Dome: 1 x 13mm Mylar 1 x 13mm Mylar

Depth: N/A Type: Fixed Position Fixed Position

Audio Speaker Wire Connection

Warranty

To secure WARRANTY COVERAGE for this unit, you must fill out an eWarranty submission at: www.breatheaudio.com

BreatheAudio™ warrants this product to be free of defects in workmanship for 5 years from the date of purchase. This applies to the original purchaser only and is not transferable. The

warranty is subject to the following conditions and exclusions: Defects caused by wear and tear, misuse, and neglect, alteration or modification, are not covered by this warranty.

This warranty is for BreatheAudio products only. Any service claims resulting from other brands used in conjunction with BreatheAudio will not be allowed or honored.

All transportation charges involved with sending and returning units to and from the warranty center is solely the responsibility of the purchaser. BreatheAudio assumes no liabilities for

damages incurred in transit to or from service center.

If the return is to be made to BreatheAudio directly, customer must first obtain return authorization by mail or e-mail. After receipt of return authorization, owner must ship product with copy

of original sales receipt, and a detailed description of the problem. Please include your return authorization number on all correspondence. Repaired products will be returned freight collect.

BreatheAudio will, at its option, repair or replace defective parts or products.

Neither BreatheAudio, nor Authorized BreatheAudio agents, nor authorized BreatheAudio Service Centers are liable for any incidental or consequential damages resulting from any defect in

or feailure of BreatheAudio products.

This warranty gives the original owner of BreatheAudio products specific legal rights, and you may also have specific rights, which vary from state to state. This warranty is expressly in lieu of