!
BREWHA!ETC130!with!Wi-Fi!FAQs!
Note:!For!ETC!Wi-Fi!models!purchased!in!2021!and!later!
!
Q1:!What!is!the!significance!when!the!controller!Wi-Fi!indicator!is!flashing?!
A1:!
1)!Rapid!flashing:!The!controller!is!in!configuration!mode!and!waiting!for!setup.!This!mode!is!
enabled!after!the!controller!is!powered!on!for!the!first!time!or!the!controller’s!Wi-Fi!is!reset.!To!
reset!the!controller’s!Wi-Fi,!refer!to!FAQ!A3.!!
2)!One!flash!per!second:!The!controller!configuration!has!failed!or!the!controller!is!far!away!from!
your!router.!Please!move!your!controller!closer!to!your!router,!make!sure!your!Wi-Fi!name!and!
passwords!are!correct.!Then!wait!for!one!minute!and!try!again.!
3)!Solid!ON:!The!controller!is!configured!and!connected!to!your!router!successfully.!
!
Q2:!How!is!a!controller!added!to!the!app?!
A2:!
1)!Download!the!app.!!
2)!Switch!the!controller!to!configuration!mode!(refer!to!FAQ!A1-1).!
3)!Open!the!app!and!tap!the!“+”!icon!in!the!top!right!corner.!
4)!On!the!configuration!page,!the!Wi-Fi!SSID!should!populate!automatically,!or!enter!it!manually,!
and!enter!the!correct!password!for!the!Wi-Fi!network.!
5)!Follow!the!guide!in!the!app!to!connect!your!device!to!your!controller’s!WIFI.!!
!
Q3:!How!is!the!controller!reset!and!switched!to!configuration!mode?!
A3:!
Press!the!“SET”!button!and!the!down!arrow!button!at!the!same!time!and!hold!them!for!about!
four!seconds!until!the!Wi-Fi!indicator!starts!to!flash!rapidly.!To!reset!all!of!the!parameters!to!
factory!defaults,!in!settings!change!“RST!Factory!Reset”!to!“Yes”.!
!
!