BrewZilla 35L User manual

Page 1of 10 http://www.KegLand.com.au Last Updated 28/09/2020 3:09 PM
How To Service and Clean Pump

Page 2of 10 http://www.KegLand.com.au Last Updated 28/09/2020 3:09 PM
Pump Servicing and Cleaning
The BrewZilla units are a reliable and an easy to maintain brewery. Under normal
circumstances it’s unlikely that you will be required to open, clean, or replace the pump.
With that said it is possible if something drops into the pump inlet causing a pump
blockage, or if mold starts to grow in the pump head (happens if the pump is not
sufficiently cleaned after use), or of the pump is just damaged for some reason then it
might be possible to remove the pump from the BrewZilla.
NOTE: NEVER clear a blocked pump by spraying water down the recirculation
arm or directly into the pump inlet, instead follow the instructions in this manual
and disassemble the pump to look for any blockages in the pump head.

Page 3of 10 http://www.KegLand.com.au Last Updated 28/09/2020 3:09 PM
Step 1
Turn the brewery upside down. Remove screws A and screws B then the base will be
able to be removed.

Page 4of 10 http://www.KegLand.com.au Last Updated 28/09/2020 3:09 PM
Step 2
Use a screw driver to remove the screws holding the pump to the side of the BrewZilla:
NOTE: Your model will have insulation foam covering the elements. If water has come
in contact with the insulation it will need to be removed and dried prior to using the
BrewZilla.

Page 5of 10 http://www.KegLand.com.au Last Updated 28/09/2020 3:09 PM
Step 3
Slide back the stainless steel spring hose clamps off the pump and use a flat head
screw driver to slip the silicon tube off the pump head.

Page 6of 10 http://www.KegLand.com.au Last Updated 28/09/2020 3:09 PM
Step 4
Remove the screws that hold the pump head on.

Page 7of 10 http://www.KegLand.com.au Last Updated 28/09/2020 3:09 PM
Step 5
Check the pump head for debris and or solids that could be stuck in the pump head.

Page 8of 10 http://www.KegLand.com.au Last Updated 28/09/2020 3:09 PM
Step 6
Check the impeller for damage or any blockage that could be stopping it from spinning.

Page 9of 10 http://www.KegLand.com.au Last Updated 28/09/2020 3:09 PM
Step 7
Look in the impeller housing and confirm no blockages are inside this side of the pump.

Page 10 of 10 http://www.KegLand.com.au Last Updated 28/09/2020 3:09 PM
Reassemble the pump.
The pump can be reassembled in the same way it was taken apart.
In order to get the silicon tubing onto the pump head it make it much easier if the silicon
tubing is wet. This will make it far easier to slip over the barbs.
Re-attach the pump using an 8mm socket (or set of pliers) and a Phillips head screw
driver or cordless drill.