QUICK START GUIDE
LOCATE THE ALARM PANEL TELEPHONE CABLE
The alarm panel telephone cable is usually going out of the alarm system
panel and connected to a telephone box as shown. Some systems have a
panel and keyboard integrated in the same enclosure.
Visit the FAQ section at https://bridgesecure.com/ for more help finding
and connecting this cable to BridgeSecure.
INSTRUCTIONS
1. Once found, disconnect the alarm panel telephone cable from the telephone box.
2. Place your BridgeSecure device near the alarm panel telephone cable plug.
3. Connect the cables following the diagrams that correspond to your situation.
4. If you are using a Wi-Fi adapter, follow its instructions to make it work with your Router.
5. Make sure your computer, tablet, or cellphone is connected to the same local network
as your BridgeSecure device.
6. Open your web browser and go to the BridgeSecure configuration pages at
bridgesecure/ or use the device finder at https://bridgesecure.com/finder/
7. Fill the BridgeSecure configuration pages. Each page contains contextual help.
8. Generate alarms from your alarm system to make sure that you receive your alerts.
The BridgeSecure Tools page allows you to check that the whole system is working
properly.
If you don’t find the cable, your alarm system may never have been connected to an
alarm central.
Alarm Panel Telephonic Cable (included)
Then use the supplied cable and make the connections as indicated here.
Get help from an alarm system installer to program your alarm system so
that it generates calls for all types of alarms. Ask for the open/close access
notifications to be included. The protocol used must be Contact ID.
