Britex BTX-09-014 User manual

BTX-09-014
Horizontal HDPE
Baby Change Table
Installation
Guide
MELBOURNE
Britex Place Mirra Crt
Bundoora VIC 3083
t(03) 9466 9000
[e-mail]
SYDNEY
16 Northumberland Drv
Taren Point NSW 2229
t(02) 9531 2100
[e-mail]
PERTH
Unit 1/8 Principal Link
Malaga WA 6090
t(08) 9249 5464
[e-mail]
BRISBANE
19 Manilla St
East Brisbane QLD 4169
t(07) 3363 2400
[e-mail]
ADELAIDE
The Britex Group
SA State Office
t1300 764 744
[e-mail]

About
The BRITEX Horizontal Baby Change Table posesses a high density bacteria resistant polyethylene body,
stainless steel hinge and mounting bracket. The antibacterial HDPE interior further reduces the risk of
contamination. An adjustable restraint belt is available for extra safety.
Choose from vertical or horizontal models.
Australia’s Finest Stainless | britex.com.au
1Australia’s Finest Stainless | britex.com.au 2
Parts and hardware
WARNING:
• Never leave the baby unattended to avoid serious injury from falling or sliding out.
• Always use the restraint belt when using the baby change table.
• Children are forbidden from hanging on the unit to avoid risk of falling.
• The total maximum recommended weight for this changing station is 20kg and babies up to 12
months. Excessive weight may create dangerous or unstable situations when in use.
• Designed for baby changing only, it is strictly forbidden to be used as an infant bed.
1. Easy to use and hygienic
The baby changing unit is manufactured using antibacterial
HDPE which helps reduce the risk of cross-contamination.
A disposable liner or blanket can be set between the baby
and the changing table.
2. Easy to open and close, space saving design
Foldable design provides space optimisation, closing the table
when not in use.
3. Built-in paper dispenser
The unit includes a built-in paper dispenser to store liners or
paper towels (by others)
4. Safety
Adjustable restraint belt fitted with click lock mechanism
5. Product use
The unit can be used in hospitals, restaurants, hotels, shopping
centres and public amenities.
Product features
1. Hooks
2. Mounting holes
3. Paper holder
4. Restraint belt
5. Table
6. 120mm Screws
7. 100mm Screws
8. Screw caps (Up)
9. Screw caps (Down)
Method of usage
Installation
1. Unfold the unit as shown on the right
2. Take a liner fom paper holder (by others)
and lay it on the table
3. Lay child in the centre of the changing table
and clip together the ends of the restraint belt
4. After use, throw the liner into the bin
and close table
Open
Close