LBC-HDBT-R-DGUser’sManual
LinkBridgeTM HDbaseTHDMIReceiverw/PoH
Broadata Technical Support, (800) 214-0222
8
3.0 MAINTENANCE AND TROUBLESHOOTING
3.1 Maintenance
Thereis no operatormaintenanceother then keepingtheunits
clean. However, observe thefollowinglight indicators tomake
sure that the unit is working properly:
3.2 Troubleshooting
If the LBC-HDBT-R-DG units do not operate properly after
installation,checkforpossiblecablebreaks,looseconnections,
and incorrect cable connections. If problems persist that may
be fiber related, contact BCI at 1-800-214-0222 for further
assistance.
For electrical problems, perform the following troubleshooting
procedures:
1. If the POWER indicator is ON, but the Link indicator is
OFF, check for the following:
a. Make sure the appropriate cables are being used.
b. Cable and cable connectors are not broken.
c. For each unit, the transmit (TX) cable is connected to
the other unit’s receiver (RX).
2. If the POWER indicator and Link indicator are ON, but
the channels are not operating, then:
a. Checktoseethatthe attacheduserequipmentisturned
on.
b. Bothendsofthelinkare connectedtothecorresponding
equipmentand tothesamecorrespondingchannelport.
c. Cable connections at both channels are securely
fastened to each connector. Turn the power off, then
back on to reset the link.