Broil King BSG343N User manual

1. ORIENTATE THE DIVIDER AS
SHOWN WITH THE NOTCH
TOWARDS THE REAR AND
PLACE OVER THE MOUNTING
PINS.
3. PLACE THE RACK SIDE RODS
OVER THE PINS IN THE SIDES
OF THE GRILL AS SHOWN IN
THE CUT-OUT VIEW. NOTE
THAT THE BENT END OF THE
SIDE ROD IS TOWARDS THE
REAR.
QUICK START GUIDE
INSTALLATION OF DIVIDERS, VAPORIZERS, AND WARMING RACK
2. ORIENTATE THE VAPORIZER
AS SHOWN AND PLACE OVER
THE MOUNTING PINS.

1. PUSH IN ON THE CONTROL KNOB AND TURN
SLIGHTLY COUNTERCLOCKWISE WHILE KEEPING
THE KNOB PUSHED IN.
2. CONTINUE TO TURN COUNTERCLOCKWISE
WHILE PUSHING IN ON THE KNOB. APPROX-
IMATELY IN THE POSITION SHOWN YOU WILL
FEEL A SLIGHT RESISTANCE AND YOU WILL
HEAR GAS BEGIN TO FLOW. MAINTAIN THIS
POSITION FOR 2 OR 3 SECONDS.
3. AFTER THE GAS HAS BEEN FLOWING FOR 2 TO 3
SECONDS, TURN THE KNOB COUNTERCLOCKWISE
WHILE PUSHING IN UNTIL THE KNOB HAS BEEN
TURNED A FULL 1/4 TURN. THE PIEZO SHOULD HAVE
IGNITED AND LIT THE BURNER. ONCE THE BURNER
HAS BEEN LIT, RELEASE THE KNOB. BE SURE THE
KNOB HAS BEEN TURNED TO THE POSITION SHOWN,
OR THE GAS WILL NOT CONTINUE TO FLOW.
QUICK START GUIDE
LIGHTING INSTRUCTIONS FOR FRONT AND REAR BURNERS
4. IF THE BURNER FAILS TO IGNITE, WAIT FOR 10
SECONDS, RETURN THE KNOB TO ITS ORIGINAL
POSITION AND BEGIN AGAIN AT STEP 1.