Brother FAX 1840C User manual

Quick Setup Guide
FAX-1840C
Quick Setup Guide
➟English … Go to page 1
FAX-1840C
Ръководство за Бързо Инсталиране
➟Български … отидете на стр. 9
FAX-1840C
Ghid rapid de setare
➟Română … mergeţi la pagina 17
FAX-1840C

1
Before you can use the machine, you must set up the hardware.
Please read this “Quick Setup Guide” for proper set up instructions.
To find the best solution for your problem or question, access the Brother Solutions Center,
http://solutions.brother.com
Keep this “Quick Setup Guide” in a convenient place for quick and easy reference at all times.
Setting Up the Machine
Setup is Complete!
Setting Up the MachineUsing the FAX as a Printer
or for PC-FAX Send
FAX-1840C
Quick Setup Guide

2
Setting Up the Machine
1Remove the protective tape and paper.
1Connect the curled handset cord to the
machine and the other end to the handset.
1Pull the paper tray completely out of the
machine and remove the output paper tray.
2Press and slide the paper guide to fit the
paper width.
3Pull out the paper support and unfold the
paper support flap.
4Fan the stack of paper well to avoid paper
jams and mis-feeds.
5Gently insert the paper into the paper tray
print side down and top edge first.
Check that the paper is flat in the tray and
below the maximum paper mark.
6Put the output paper tray back on and push
the paper tray firmly back into the machine.
1Removing the Protective
Parts
2Installing the Handset
3Loading Paper
You can load up to 100 sheets of 80 g/m2
paper.
For more details, see “About paper” in
Chapter 1 of the User’s Guide.
Use the paper support flap for Letter, Legal
and A4 size paper.
■Make sure the paper side guides touch the
sides of the paper.
■Be careful that you do not push the paper
in too far; it may lift at the back of the tray
and cause paper feed problems.
Paper Side Guide
Paper Support
Paper Support Flap

3
1Connect the power cord.
2Connect the telephone line cord.
Connect one end of the telephone line cord
to the socket on the machine marked LINE
and the other end to a modular wall socket.
Warning
■The machine must be fitted with an earthed plug.
■Since the machine is grounded through the power
outlet, you can protect yourself from potentially
hazardous electrical conditions on the telephone
network by keeping the power switched on when
you connect the machine to a telephone line.
Similarly, you can protect yourself when you want
to move your machine by disconnecting the
telephone line first and then the power cord.
Warning
If ink gets in your eyes wash them with water
immediately, and if irritation occurs consult a doctor.
1Make sure that the power is turned on.
The LCD shows:
2Open the top cover.
3Remove the protective parts.
4Installing the Phone Line
and Power Cord 5Installing the Ink Cartridges
No Cartridge
Do not throw away the protective parts.
You will need them when you transport the
machine.
Top Cover
Continued...
Setting Up the MachineUsing the FAX as a Printer
or for PC-FAX Send