BUD CWB-15101 User manual

CWB-15101 Instruction sheet rev 7-2022 pg. 1
CWB-15101 Instruction sheet
Thank you for using BUD’s corner mounting bracket.
NOTE: This product is designed to help mount any of BUD Plastic and Aluminum diecast enclosures
from 3” up to 14” wide, and up to a total of 25 Lb.
Assembly:
1. start with connecting the mounting tray (15101-CE) to the enclosure mounting strip (15101-MB)
using one of the ¼” carriage bolts and one ¼” wing nut paying attention to place the nut on the
tray side.
2. with the enclosure mounting surface up (so mounting holes are visible), place the mounting
strip you have just assembled on the mounting surface so the carriage bolt is near the middle of
the enclosure mounting edge. based on the mounting screws size, allign either the narrow or
wide slots with the mounting holes in the enclosure (you may need to flip the mounting strip so
it is alway overlapping with the enclosure and not hanging down). The matching holes may shift
the center of the strip off the center of the enclosure.
NOTE: The enclosure can be mounted upword or downword from the bracket.
NUT
UP (recommended)
DOWN
CWB-15101 kit
includes:
Qty
part
1
15101-CB
1
15101-CE
1
15101-MB
2
¼”-20 X ½”
CARRIAGE
BOLT
2
¼”-20 X ½”
WING NUT
2
#8X2”
DRYWALL
SCREWS
1
INSTRUCTION
SHEET

CWB-15101 Instruction sheet rev 7-2022 pg. 2
3. Assemble 2 enclosure mounting screws (not supplied) to scure the strip to the enclosure, and
use your hand to break off any parts of the strip that are sticking out of the sides of the
enclosure.
4. Mount the corner bracket (15101-CB) onto a corner of two walls using the 2 supplied #8 x 2”
drywall screws according to the mounting oriontation you have chosen (the bracket should
overlap with the enclosure back) . with heavy enclosures it is reccommended to use the
additional holes in the bracket.
NOTE: you should leave room to have hand access the bottom (flat) side of the corner bracket while
doing the final mounting of the enclosure.
5. drop the ¼” carriage bolt in the square hole in the tray (it is recommended to use a piece of tape
over the bolt’s head to temporaly keep it from moving up) and assemble the tray to the corner
bracket using one one ¼” wing nut, paying attention to place the nut on the corner bracket side.
6. Adjust to desiered distance from the walls.
Assembly of the corner bracket is done.
These instructions can be viewed on Bud Industries website at :” https://www.budind.com/wp-
content/uploads/CWB-15101-Instruction-sheet.pdf”
UP
DOWN
Tape