Bush BEUCL6082 User manual

1

2
Customer service manual
Built Under Larder
Contents
1
Precautions
Page 2
2
Door
Page 4
3
Thermostat Setting
Page 6
4
Replacement Lamp
Page 7
5
Replacement Door Switch
Page 8
6
Additional Support
Page 9
Precautions:
Always follow safety advice.
Always switch off and unplug the appliance before attempting to remove any part.
Always wear appropriate protective equipment when carrying out any work.
Always use the correct tools for carrying out any work.
Some repairs may not be suitable for unqualified users to carry out. If in doubt seek the advice of
a profession repairer.

3
SAFETY PRECAUTIONS

4
REPLACEMENT PROCEDURE
Applicable models
EN
General
Part name
Door
A- Changing The Door Swing Direction to Right Hand
1- Unscrew the two screws fixing the top hinges (Fig-1) and bottom hinges. (Fig-2) Remove the doors. (Fig-1)
Figure 1
Figure 2
2. Remove the top hinge screw caps (big) on the left side (Fig-3) and insert them to the right side. (Fig-4)
Figure 3
Figure 4
3. Remove the bottom hinge screw caps (big) on the
left side and insert them to the right side. (Fig-5)
4. Unscrew the two screws fixing the top hinge and
bottom hinges. Remove the hinges. (Fig-6)
Figure 5
Figure 6
5. Assemble the top hinge to the bottom of the door (Fig-7) and assemble the door and then assemble the
bottom hinge to the top of the door. (Fig-8)

5
Figure 7
Figure 8
REPLACEMENT PROCEDURE
Applicable models
EN
General
Part name
Door
B- Changing The Freezer Door Swing Direction
1- Unscrew the screw fixing the freezer door hinge (Fig-1) and remove the freezer door (Fig-2)
Figure 1
Figure 2
2- Unscrew the screw fixing the freezer door holder
and remove it. (Fig-3)
3- Screw the freezer door holder to the right side. (Fig-
4)
Figure 3 Figure 4
4- Assemble the freezer door and fix the freezer door
hinge by tightening the screw. (Fig-5)
Figure 5

6
REPLACEMENT PROCEDURE
Applicable models
EN
General
Part name
Thermostat
Setting

7
REPLACEMENT PROCEDURE
Applicable models
EN
General
Part name
Replacement Lamp
Unscrew the screws which are fixing the lamp cover and change lamp.

8
REPLACEMENT PROCEDURE
Applicable models
EN
General
Part name
Replacement the Door
Switch
Stick a tape to protect the body plastic. Flex it with the
help of a tool like a slotted screwdriver
Also flex the top-side of the switch and then displace
by pulling.
Put the switch connector cable in the housing. First place the top-side of the switch and then push the bottom
side.
After the switch is placed, complete the assembly by pushing.

9
ADDITIONAL SUPPORT
Applicable models
EN
General
The following parts are available for the customer to undertake repairs at their own risk.
Please carefully follow the guidance given in this manual including all safety measures.
•Door Handles
•Door Hinges
•Trays
•Baskets
•Door Gaskets
Parts can be obtained by calling the support service listed in this section.
All repairs in this manual can be achieved using commonly available tools.
If you are in any doubt of your ability to carry out a repair, please use a professional repairer, also
available through the support service.
Damage sustained to the appliance or future faults arising from poorly carried out repairs will not be
covered under warranty.

10