3) Turn ON / OFF
To turn ON your HALO 360 light:
• press ONCE on the ON/OFF button - a little
green LED light will turn ON
• press TWICE the ON/OFF button to turn it OFF
- the little LED light will turn OFF
Warning
We have made a closed light for better environ-
ment protection. Please note that over 1h of use
the light does get very hot. This is not a defect
not a cause to open a claim. This is normal and
you are using a very powerful light. Store in a dry
and safe place.
6) USB port
4) Temperature
The Halo 360 Light has 3 different possible color
or temperature.
• 3000°F / 4000°F / 5200°F
• Orange / Warm / Cold
You can press “CCT” button and scroll to the
necessary temperature.
5) Dimming
The Halo 360 Light has 6 dimmable positions.
• 0% / 20% / 40% / 60% / 80% / 100%
Turn charge the dimming on the light, press as
follows the DIM button until you have the
necessary brightness.
• When on position 0% the Halo 360 Light is still
ON and still allows you to change the brightness.
Open
Open the HALO 360 Light, and you may take it
out of its box. It is made of aluminium to allow
maximum heat dissipation. Please note that the
Halo 360 will get very hot when running ON in full
power. This is normal with such powerful light.
1) Charging
When you receive the Halo 360 Light, it has been
tested and it is not fully charged. Please do
charge it when you receive it with the USB-C port.
The LED will indicate red. Charging will take over
an hour. It is not possible to turn ON the light
when charging it.
2) Install
The Halo 360 Light has a male ¼” thread on the
top and a female ¼” on the bottom. This is to
easily set up on a ¼” camera tripod or a Bushman
Monopod. On the top of the Halo 360 Light is
a red ring that allows a better grip for your
camera or for stacking multiple Halo 360 Lights.
You can easily screw on the Halo 360 Light on
a ¼” thread.
1
2
3
4
56
