4
The camera is connected to the RCA of the TV via the TV cable and
the camera function switch to the "TEST" test preview mode. Select
"REPLAY" to view the image file in the camera.
Note: After connecting the TV, the camera display
automatically turns off!
1.6 Attention
On “TEST” mode, camera will be auto power off while no
keypad controlling. Please switch to “TEST” mode again if
you want to continue to use.
Please keep power on during upgrade process, after upgrade
finished, it needs to keep at least 5 seconds before you can
shut down or cut off power, otherwise it may cause upgrade
failure.
When install camera please make sure there are no moving
objects in 3m area in front of lens such as branches, leaves,
weeds, strings, color ribbon and other objects which may
flutter in the wind to avoid potential false triggers.
Please do not aim the camera at a heat source such as boiler,
exhaust vents and light, etc. Avoid mistaking photos or videos
and shortening stand-by time.
Please do not use the voltage and current does not meet or
exceed the requirements of the product of the external power
supply, so as not to cause damage to the camera.
The battery inside the camera keeps the clock, the date and
time settings will remain until the battery runs out. After the
battery is disabled, the date and time settings will be reset to
the factory settings after power failure, and need to be reset
after each power.
