PLEASE READ BEFORE INSTALLING
These products must be installed in accordance with the latest Building and IEE
wiring regulations. If in any doubt, please contact a qualified electrician.
1 GANG 10 AX INTERMEDIATE TOGGLE SWITCH.
RATED AT 10AX 250V~
IMPORTANT NOTES
TECHNICAL SPECIFICATION
EN
The Warranty Period of Two (2) years from the date of the original purchase.
Buster and Punch encourages all its customers to make note of this
symbol and avoid putting any waste electrical goods in your domestic
waste bin or container. Please ensure you take your waste electrical
goods to a suitable facility for disposal.
We recommend you to use a UK back box to install your product. Please note that
the minimum recommended depth for the mounting box is 47mm. Back boxes are
available to purchase from us, please see recommended sizes below:
WARRANTY INFORMATION
RECYCLING ELECTRICAL PRODUCTS
BACK BOXES
1
ON
OFF
BEFORE COMMENCING WORK, ISOLATE THE
MAINS POWER SUPPLY AND REMOVE THE
FUSE IN THE FUSE BOX OR SWITCH OFF THE
CIRCUIT BREAKER IN THE CONSUMER UNIT.
If unit is to be used as a replacement for an existing product, remove existing unit from its
location and disconnect the wiring.
Certain items in the range will not fit into a 4 lug box. If such a box has been previously
installed the top and bottom lugs should be removed or bent back to avoid contact with the
interior.
Use a cross head electric or manual screwdriver to fit the special countersunk screws until
tight.*
CAUTION:
To reduce the risk of discolouration or
tarnishing, avoid installation on wet plaster.
Turn power back on.
By hand, screw the coin caps into the end of the screws. Use the plastic coin cap tool to fully
tighten the coin caps.**
** Do NOT use a standard screw driver to tighten the coin caps. This may damage the cap and is not covered under
warranty. Plastic coin cap tool must be used by hand only.
Connect the wires as shown in appropriate wiring diagrams. Use green/yellow sleeving
on earth conductors that are not insulated. Ensure terminals are properly tightened and
no bare wire is visible. Push back unit into moulding box making sure conductors are not
trapped.
CAUTION:
Verify power is OFF to switch before proceeding.
2
3
4
10AX INTERMEDIATE SWITCH AND TOGGLE SWITCH
5 6
7
To earth
terminal
in box.
Phase 2
Neutral (blue)
Live (brown)
Earth (yellow and green)
ON
OFF
!
* Please ensure screws are sufficiently tight to support the product but please do not over tighten as this may cause some
deformation to the plate or damage the screw.
TOGGLE PLATE RECOMMENDED BACK BOX
1G 1G UK Back box – SKU# ELB921
INTERMEDIATE SWITCH
L0075
BUSTERANDPUNCH.COM
ELECTRICITY
INTERMEDIATE SWITCH
