Bzooma P43-Sprint User manual

Marketed in Australia and New Zealand by Bzooma Pty Ltd ABN 37 640 907 07
P43-Sprint Wheelchair
Owner’s Manual
Marketed in Australia and New Zealand by Bzooma Pty Ltd ABN 37 640 907 07
Marketed in Australia and New Zealand by Bzooma Pty Ltd ABN 37 640 907 07

1
TABLE OF CONTENTS
Table of Contents ............................................................................................................................................... 1
Introduction ....................................................................................................................................................... 1
Bzooma Pty Ltd .................................................................................................................................................. 1
Controller ........................................................................................................................................................... 2
General Maintenance ........................................................................................................................................ 3
Troubleshooting of controller............................................................................................................................ 4
Charging The Battery .........................................................................................................................................
Battery Power Display .......................................................................................................................................
Disassembly For Transport In A Car ...................................................................................................................
Product Specifications ....................................................................................................................................... 6
INTRODUCTION
Your P43 wheelchair is easy to operate however you will need to read this manual first to ensure you
fully understand the controls of the vehicle. Following that you must gain experience in a safe place with
practice, in order to ensure your safety when you go traveling.
Bzooma takes pride in improving your quality of life. You should be able to reach all the places you need
to visit in your neighborhood with ease and safety.
Your P43 wheelchair is manufactured to the highest standard of quality possible, and uses the finest
components coupled to the latest technology available. Your safety relies upon your responsible use of
this machine.
BZOOMA PTY LTD
This User Manual is written and published according to the latest BZOOMA PTY LTD specifications. We
will continue the policy of improvement and may make some changes in the design and specifications
without notice. If you have any enquiries, please contact your local dealer or visit directly from this web
site bzooma.com.au.
This manual is published by Bzooma Pty Ltd

2
CONTROLL ER
The controller consists of a joystick, speed control battery power indication.
Power
Press the switch once, the controller is on; press it again, the controller is off. If the power
indicator is on, the Sprint is ready to go.
Security
As a security measure, with switch on, press the power button for at least 2 seconds. The
controller is then locked. The procedure to unlock is simple: - Press the switch once, the LED on
the controller will turn from green to red. Press the horn button once and in 10 seconds, the
controller will unlock itself automatically.
If you think you will ever need this feature it is suggested that you practice it safely at
home to become familiar with the procedure.
Speed control
To increase your speed press the Fast button. The more you press it, the faster you go. You
must use this feature cautiously until you are familiar with the Sprint’s reactions, your driver
experience, and the environmental situation you are driving in.
Joystick operation
The joystick on the controller commands the movement of the electric wheelchair.
1. Move forward and backward: Push the control rod forward or backward with your hand and the
Sprint will respond. If you take your hand off the joystick the Sprint will stop.
2. Turn left and right: To turn right or left simply move the joystick accordingly.
3. Brake: If you cease all commands using the joystick the Sprint will stop automatically.
4. Adjustments
Battery power indicator
Speed controller
Joystick
Power button
Horn button

3
There are comprehensive adjustments to the seating position to suit all people, including the
angle and width of the arm rests, angle of the back of seat and foot rest adjustment.
Footrest adjustments.
Manual push mode
Your wheelchair can be adjusted to free wheel, which disengages the motor drive and enables it
to be pushed. To manually push the wheelchair, turn the levers located on each motor inward
90 degree. This mode also disengages the electric brakes, so extreme caution must be taken.
GENERAL MAINTENA NCE
1. Pressure of tires- Check the pressure of tyres regularly. If there is a pinhole in your tire, sealant
on the tire can repair it automatically. If damage is worse, you will need to refer to your dealer.
2. Storage-Charge the batteries if you intend to store the wheelchair for an extended period.
Occasional recharging during prolonged storage will protect your battery. If storage is to be for a
prolonged period it is best to disconnect the battery.

4
TROUBLESHOOTING OF CONTROLLER
The controller LED will flash according to the following settings, if problems persist, please consult your
dealer.
Number Reasons Settlements
1 Time delay or error in
operation
Unloosen the rocker
and restart it
2 Troubles of the
batteries
Check the batteries and
wire cable, recharge or
replace batteries
3 Troubles of the left
motor
Check the left motor,
joints and wire cable
4 Troubles of the right
motor
Check the right motor,
joints and wire cable
5 Troubles of the left
brake
Check the left brake,
joints and wire cable
6 Troubles of the right
brake
Check the right brake,
joints and wire cable
7 Troubles of the
controller
Check the wiring and
joints and replace the
controller
8 Troubles of the
second controller
Check the wiring and
joints and replace the
second controller
9 Troubles of the
communication of the
controller
Check the cable and
joints and replace the
controller
10 Unknown troubles Check all cable and
joints and contact the
follow - up services
section

5
11 Troubles of the
direction control
Wrongly connecting,
check whether the
controller match the
second controller
CHARGING THE BATTERY
The charger has intelligent technology that will charge your battery in the shortest possible time,
while protecting the life of your battery. The charger is designed to protect your battery from
damage including overcharging, overheating and short circuit.
The battery is a high quality unit, and with normal use and care it will serve you well. With time it
will only gradually lose range and power, but will remain functional, and should give a long
service life. It is important to never fully discharge your battery because running it low will
reduce its service life. It is best practice to recharge often.
1. Insert charger plug into the controller charge point, then insert power port to the AC outlets
and then turn power on.
2. The LED light of the charger will turn RED while charging.
3. When fully charged the LED light will turn GREEN. The charger is a smart charger which
will reduce charging to a background level when the battery is full charged. Do not leave on
for more than three hours after the green light has indicated that charging is complete.
4. After charging, first turn off power and pull the AC power plug, then pull out the charger plug
from the machine’s controller.
BATTERY POWER DISPLAY
If two green indicators light up, it means the battery is fully charged; if the two yellow ones light
up, it means the battery should be recharged. If two red lights illuminate, that means the
recharging is extremely urgent.
DISASSEMBLY FOR T R ANSPORT IN A C AR
Your Sprint is easily disassembled for ease of transport. The four components when
disassembled are: -
1. Seat and rod controller parts
2. Frame and motor parts
3. Foot pedal
4. Batteries
充电器接口
Charger jack

6
Please disassemble in the following steps, and reassemble will be in the opposite steps.
1. Shut off the power; get hold of the foot pedal to pull out the plug.
2. Pull out the big black plug along the conducting wire of rod controller to armrest. (Pay attention
to how the wire goes along the parts in front of pillar of seat and is connected)
3. Unloosen the screw nut on the pillar of seat, pull out the screw bolt, lift the seat and
disassemble it.
4. Take down the battery by unloosening the screw of anode tap of battery, and then unloosen the
one of cathode tap.
PRODUC T SPECIFICATIONS
Type
Item
P43
Overall dimension 750×600×950 mm
Front wheel 4"×2 PU solid tyre
Driving wheel 12"×4"×2 Air tyre
Rear wheel 5"×2 PU Tyre
Driving system Gear driving
Braking system Electric regenerative braking
Max. speed 0-8 km
Duration 5 h
Range About 35km
Max.climbing gradient 10゜±2゜
Weight 75kg
Max. load 150KG
Turning radius 500 mm
Ground clearance 80 mm
Controller
PG
Battery
12V 35AH×2PCS(Lead-acid
battery)
Charger
DC24V/6A automatic charger
Motor
270W×2pcs

7
WARRANTY
Bzooma Pty Ltd Limited Warranty
Bzooma Pty Ltd provides this Limited Warranty to the
original purchasers of new Bzooma machines in Australia
and New Zealand.
Bzooma Pty Ltd guarantees the machine, power base
including Motor, Battery and charger, against defects in
materials and workmanship for a period of one (1) year,
from date of delivery to the original purchaser. Damage
caused by accident or obvious abuse is not covered by this
warranty.
To make a claim covered by this warranty the purchaser
must contact an authorised BZOOMA Pty Ltd Dealer for
inspection and service. Indications of abuse, accident, or
unauthorised tampering with the machine power base
mechanical, or electrical equipment, will void any claim.
Bzooma Pty Ltd is not responsible for transport costs
associated with obtaining service or repairs under this
warranty.