C Systems URRS-24T User manual

Installation Manual
URRS -24T
Ultrasonic Rodent Repellent System
Manufactured by
C Systems Pvt Ltd

URRS control panel terminal block
Connection details between C Systems URRS control panel and
transducers. Fig A & B shows the possible wiring methods
between transducers and Panel.
The maximum distance from the panel to last transducer shall
be 130m in case of looping is desired (Fig-B)
Procedure for URRS installation at site

Select a proper location near the electrical power socket
of about 5 A AC. Fix the panel with the help of key holes
provided at the back of the panel. No brackets and
accessories are required for mounting.

Proper earthing has to be done in the AC socket to
avoid unnecessary leakage current. Also check of
proper voltage at AC socket

Each transducer covers an area of respective Sq ft as per
models.

The transducer consists of 2 parts, top cover and bottom
lid. Use a ¾ inch or 1 inch electrical junction box to mount
the bottom lid. The holes in dummy plate in junction box
exactly suit the holes in the bottom lid.

After termination, press the top cover over the bottom
lid. Press and lock type.

Each transducer can be connected to the controller via
separate cable or by connecting the transducers in
parallel.

 Cables shall be either in GI or PVC conduit.

Ultrasonic Rodent Repellent System Control Panel:
Features:
1. 2 x 16 alpha numeric LCD with back light
2. Power ON LED indication.
3. 4 keys for menu navigation.
4. Power amplifier output for connecting ultrasonic
transducers.
5. Audible tone for transducer testing
6. User selectable wave sweep time, & wave sweep delay
setting. Default sweep time is 1 ms (1 to 10ms). Default
Sweep delay 2 sec (1 to 10 sec).
7. A volt free contact is provided in the panel to monitor the
power on healthy status of the panel.
Menu Setup
1. Menu navigation can be achieved using Up, Down, Enter & Exit
2. To enter to the menu, Press Enter.
3. All the parameters are factory programmed and no manual
settings are required.
4. To test the operation of transducer, press “Enter” from
main screen & press up /down key till you see “TEST
Transducers”.
5. Press Enter key. An audible sound will be heard from all
transducers. This ensures that all the transducers are
working normally.
6. To change the site name, navigate the menu to select
“SITE NAME” by pressing UP/DOWN key.
7. Press Enter to edit the Site Name. Press Enter to save
& Exit.
Modbus Integration
All the parameters sent in the panel can be monitored through
MODBUS RTU protocol via any standard BMS. Refer Modubus
document for details.