Step Two: Arm Assembly
Arms should be installed with curve side on the in-
side of the chair. (Left Picture). Place Arm on top
of Front Leg. Align pre-drilled hole in arm with the
pre-drilled hole located at the top of the Front
Leg. Install a short connector bolt through pre-
drilled hole in the Front Leg, then through pre-
drilled hole under arm. Install flat washer, lock
washer and nuts. Do not tighten at this time.
Repeat process on other side.
Step Three: Arm & Back Attachment
Install (1) short connector bolt through pre-drilled hole
through arm and through upper back yoke (Right Picture).
Finger tighten flat & lock washers and nuts. Do not tighten at
this time. Repeat process for opposite side.
Step Four: Back Assembly
Place Back Assembly on top of mounting surface of Rear
Legs, (Left Picture). Push Back Assembly forward until it’s
aligned with Seat Assembly. Hold Back Assembly in place and
install (4) Robertson Head Screws into the base on each side.
There are no predrilled holes, you need to align the
horizontal bar with the sides of the base, making sure that
the base of the backrest aligns with the seating surface.
Step Five: Tightening of Hardware
Tighten all connections. Do not over tighten!!! Over tightening of hardware can cause
damage to the item.
