Cabletime MediaStar 514 User manual

REGULATORY REQUIREMENT NOTICES
EUROPE
Cabletime Limited declare that the products described in this manual conform to the requirements
of the following Directives:
• 89/336/EEC
• 92/31/EEC
• LowVoltageDirective73/23/EEC
THE STANDARDS APPLIED ARE:
BSEN55022:1998 Limitsandmethodsofmeasurementofradiointerferencecharacteristicsof
information technology equipment
BSEN50082-1:1998 Electromagnetic compatibility - generic immunity standard
BSEN60950-1:2000 Specification for safety of information technology equipment, including electrical
business equipment
BSEN60065:2002 Audio Video and similar electronic apparatus safety requirements
UNITED STATES OF AMERICA
Cabletime Limited declare this equipment has been tested and found to comply with the limits for a Class A
digitaldevice,pursuanttoPart15oftheFCCRules.Theselimitsaredesignedtoprovidereasonableprotection
againstharmfulinterferencewhentheequipmentisoperatedinacommercialenvironment.Thisequipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructionmanual,maycauseharmfulinterferencetoradiocommunications.Operationofthisequipmentin
a residential area is likely to cause harmful interference in which case the user will be required to correct the
interferenceathisownexpense.
• Thisdevicecomplieswithpart15oftheFCCRules.
Operation is subject to the following conditions:
• Thisdevicemaynotcauseharmfulinterference,and
• Thisdevicemustacceptanyinterferencereceived,includinginterferencethat
maycauseundesiredoperation.
Whilst all reasonable care has been taken to ensure the accuracy of this publication, the publishers and authors cannot
acceptresponsibilityforanyerrorsandomissions.CabletimeLimitedreservestherighttorevisethispublicationandto
makechangesinthecontentfromtimetotimewithoutnotice.
Copyright©Cabletime2007.Allrightsreserved.Nopartofthisguidemaybereproduced,storedinaretrievalsystemor
transmitted in any form or by any means (electronic, mechanical, photocopying, recording or otherwise) without prior written
permissionofCabletimeLtd.
CabletimeLimited,64GreenhamRoad,Newbury,Berkshire,RG147HXEngland
Email:[email protected]
GettingStartedWithMediaStar514WiredRemoteControl
TheMediaStar514WiredRemoteControlcanbeusedwithallMediaStar
systems where a wired push button controller is required, rather than the
standardinfra-redremotecontrolandIRreceiver.Thisunitconnectstoeither
theMediaStarEvolution760and760/xMunits,MediaStarPro507Micro
Settops,orMediaStarCompact751receivers(allreferredtoas‘endpoints’in
thisdocument).
 WHAT’SINTHEBOX
• 514WiredRemoteControl
• 514QuickReferenceCard
QuickStartGuide
IMPORTANT
ThisunithastobePROGRAMMEDtooperatecorrectlywitheach
typeofMediaStarendpointequipment.Programminginstructionsare
shownbelow.Ifthisunitispluggedinbutkeypressesdonotgetany
response from the system, it is likely the Wired Remote Control has
been programmed to work with the wrong type of MediaStar endpoint
equipment.
3.5mmjack
Red LED
Page4

IMPORTANT SAFETY INSTRUCTIONS
1. Readtheseinstructions.
2. Keeptheseinstructions.
3. Heedallwarnings.
4. Followallinstructions.
5. Donotusethisapparatusnearwater.
6. Cleanonlywithadrycloth.
7. Donotblockanyventilationopenings.Installinaccordancewiththe
manufacturer’sinstructions.
8. Donotinstallnearanyheatsourcessuchasradiators,heatregisters,stovesor
otherapparatus(includingampliers)thatproduceheat.
9. Donotdefeatthesafetypurposeofthepolarisedorgrounding-typeplug.A
polarisedplughastwobladeswithonewiderthantheother.Agroundingtype
plughastwobladesandathirdgroundingprong.Thewidebladeorthethird
prongareprovidedforyoursafety.Iftheprovidedplugdoesnottintoyouroutlet,
consultanelectricianforreplacementoftheobsoleteoutlet.
10.Protectthepowercordfrombeingwalkedonorpinchedparticularlyatplugs,
conveniencereceptaclesandthepointwheretheyexitfromtheapparatus.
11.Onlyuseattachmentsoraccessoriesspeciedbymanufacturer.
12.Useonlywiththecart,standtripod,bracket,ortablespeciedbythe
manufacturer,orsoldwiththeapparatus.Whenacartisused,use
cautionwhenmovingthecart/apparatuscombinationtoavoidinjury
fromtip-over.
13.Unplugthisapparatusduringlightningstormsorwhenunusedforlongperiodsof
time.
14.Referallservicingtoqualiedservicepersonnel.Servicingisrequiredwhenthe
apparatus has been damaged in any way, such as power-supply cord or plug is
damaged, liquid has been spilled or objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture, does not operate normally, or has
beendropped.
INSTALLATION
Start by removing the existing IR receiver module from the endpoint by
unpluggingits3.5mmjackplug.ForMediaStarCompact751units,thebuilt
in IR receiver may be currently used, so there may be no external IR receiver
jackplugtoremove.
Insertthe3.5mmjackplugoftheWiredRemoteControlintotheendpoint’s
jacksocket.
As each key is pressed, the red light on the front of the Wired Remote Control
willashonce.TheMediaStarendpointunitshouldrespondinthesame
mannerasiftheinfra-redremotecontrolisused.Ifitdoesnotrespond,then
the appropriate IR address mode should be programmed into the Wired Remote
ControlUnit,asdescribedbelow.
Note: whenusingthe514withaMediaStarPro507unitusingV6(orearlier)
software,usetheINFOkeyinsteadoftheNEXTkeywhenpromptedinthe507
on-screenmenus(pressingOKonthe514willhavenoeffect).
PROGRAMMINGTHEIRADDRESS
1. UnplugtheWiredRemoteControl3.5mmjackplugfromtheendpoint
unit.
2. PressandholddowntheGreenandINFObuttonsatthesametime.
3. Plugthe3.5mmjackcablebackintotheendpointunitwiththebuttonsstill
presseddown.TheredLEDwillthenbeilluminatedtoindicatetheunitis
inProgrammingMode.ReleasetheGreenandINFObuttons.
4. TheunitisnowawaitingentryoftheMediaStarendpointtypetooperate
with:
• Press1forMediaStarPro(507)
• Press3forMediaStarEvolution(760,760/xM)
• Press5forMediaStarCompact(751)
5. Onceanumberkeyhasbeenpressed,theLEDwillashthe
correspondingnumberoftimestoconrmselectionofthatIRAddress.
6. TheWiredRemoteControlwillthenreturntonormaloperation,witha
singleLEDasheachtimeakeyispressed.
Page2 Page3