CableWholesale 41V3-08100 User manual

HDMI Splitter
1 x 8
User Manual

1
Dear customer
Thank you for purchasing this product. For optimum performance and safety, please read
these instructions carefully before connecting, operating or adjusting this product. Please
keep this manual for future reference.
Ⅰ.INTRODUCTION
1×8 HDMI splitter distributes1 HDMI source to 8 HDMI displays simultaneously. It
offers HD video solution for super market, shopping Mall, HDTV/STB/DVD/Projector /DVR
factory, data control center, information distribution, conference room presentation,
education and training, corporation showroom, luxurious house, etc.

2
Ⅱ.SPECIFICATIONS:
Input Video Signal 0.5-1.0voltsp-p
Input DDC Signal 5voltsp-p（TTL)
Max Single Link Range 1920×1200,1080P
HDMI 480i/576i/480p/576p/720p/1080i/1080P
DVI 480p/576i/576p/720i/720p/1080i/1080p
HDMI Version HDMI1.3
Bandwidth Upto225MHz
EDID Duration 12seconds
Power supply DC 5V / 2A

3
Ⅲ. CONNECTION AND OPERATION
1). Connect HDMI source and displays into the Splitter.
*please refer to the Connection Image.
2). Connect the DC 5V/2A power supply into the splitter. Make sure you can not connect a
power supply with voltage higher than 5V, or the splitter may get damaged.
3).Turn on the power switch.
4).When all input and outputs are connected and turned on, the corresponding LED will
light.
*Attention: In order to protect the splitter and your devices, please don't turn on the power
switch of the splitter before input source and output displays are attached in, make sure the
splitter is powered off before you insert and extract HDMI cables, and please insert and
extract HDMI cables gently.

4
Ⅵ.INTERFACE SPECIFICATONS:
1).Power switch
2) HDMI input LED
3) HDMI output LED
4) HDMI output
5 HDMI input
6 Power Supply Socket
v. BOX CONTENTS:
Item Qty Remark
1×8 HDMI splitter 1pcs
Power supply 1pcs DC 5V@3A
User Manual 1pcs English

5
IV. FAQ:
1). The splitter doesn’t appear to be functioning.
Check if the LED lights, the power supply is connected and the power switch is turned on.
Make sure all cables are well connected, and in good condition. You’re encouraged to try
different cables on the splitter. Make sure the system of connecting the input source to the
displays directly works well.
2). The LED doesn’t light.
Make sure you use the accessory power supply of the splitter. Power supply connected
with voltage higher than 5V may damage the splitter.
3) If the maximum resolution of the four displays is not the same, what resolution will be
displayed?
In order to make sure each display works normally, the splitter will display at the lowest
resolution.

6
IIV. CONNECTION IMAGE: