CALRAD Electronics 72-149 User manual

Electronics
For technical assistance
call: 323-465-2131
CALRAD
R
The 72-149 provides a simple solution for providing ethernet connectivity over RG59 \ RG6u coax. Extends any networking devices
up to over 1,600 ft. at 100Mbps supports Full Duplex and Half Duplex modes. The 72-149 is completely transparent to all protocols
and applications. Works with IP CCTV camera’s, VOIP Phones and all consumer based IP technologies like Computers, Smart TV’s,
Digital STB’s, Network Switches, Wireless Access Points, etc.. Includes two Bi-directional Transmitter and Receiver units each unit
acts as a Transmitter and or Receiver. Easy to configure dip switches for connectivity options. 1 x L.E.D. Power Indicator, 2 x Mode
settings L.E.D. indicators, 2 x RJ45 network data L.E.D. indicators. Includes 2 x 72-149 Transmitter\Receiver units, 2 x 12Vdc power
supplies.
Typical Hookup
Features \ Technology For all the latest product information visit our website at: www.calrad.com
2 x 72-149 Ethernet Extenders
2 x DC Power Supplies
Part No. 72-149
Ethernet over
RG59, RG6U
Coax Extender,
10/100Mbps
Specifications
Copyright CALRAD ELECTRONICS 2020All specifications subject to change without notice
Package Contents
Power Supplies
Function
Settings
(Dip Switches)
Power
12Vdc
Power
12Vdc Function
Settings
(Dip Switches)
L.E.D.
Indicators
L.E.D.
Indicators
CALRAD
Part No. 72-149
Ethernet over Coax Extender
Transmitter\Receiver
Ethernet Extender
1
ON
2341
ON
234
FUNCTION
LINK SPEED
ETHERNET
LONG DISTANCE
100BASE-T1
10M
1
2
3
4
100M
OFF
OFF
OFF
ON
ON
ON
CALRAD
Part No. 72-149
Ethernet over Coax Extender
Transmitter\Receiver
Ethernet Extender
1
ON
2341
ON
234
FUNCTION
LINK SPEED
ETHERNET
LONG DISTANCE
100BASE-T1
10M
1
2
3
4
100M
OFF
OFF
OFF
ON
ON
ON
BNC
Jack
BNC
Male
BNC
Male
BNC
Jack
Ethernet
Jack
Ethernet
Jack
RG59, RG6U
Coax Cable
NVR
SWITCH
IP CAMERA
COMPUTER
(Point to Point Transmission)
Cat5e, Cat6
UTP Cable
Cat5e, Cat6
UTP Cable
MAX
100 Mbps
10 Mbps
1,650 ft.
MAX
100 Mbps
10 Mbps
429 ft.
825 ft.
MAX
100 Mbps
10 Mbps
429 ft.
825 ft.
3,300 ft.
Front View
Rear View
100M 10M
1 2
1
ON
234
SETTING
DC 12V
+ON
STATUS
STATUS
1
2
Transmitter\ Receiver
Transmitter\ Receiver
12Vdc
Power
Supply
12Vdc
Power
Supply
72-149-02212020-WB Page 1 of 2
Example(A)
Example(B)
Example(A)
Example(B)
Product Instructions
Network Standards: IEEE 802.3 10 BASE-T Ethernet, IEEE 802.3u 100BASE-TX Fast Internet, IEEE
802.3 bw 100BASE-T1 Ethernet, IEEE 802.3 Nway Auto-Negotiation, IEEE 802.3x Full Duplex
Operation and Flow Control, IEEE 802.3az Energy Efficient Ethernet.
Data Rate: 10Mbps \ 100Mbps, Supports: Auto MDI\MDI-X
RJ45 Distance Cat5e (Max): 100BASET-TX (429 ft.) / 10BASE-T (825 ft.), 100BASE-T1 (900 ft.),
Long Distance 100 Mbps (1,650 ft.) / 10 Mbps (2,640 ft.).
Ethernet Connector: 1 x RJ45 Jack, Built-in 1.5KV (Line to Line) Surge Protection
Coaxial Connector: 1 x BNC 75 Ohm, Built-in 30KV (ESD) and 30A (Lightning) Surge Protection
Panel L.E.D. Indicators: Green (Power), Blue (Mode1, Mode2)
Ethernet RJ45 L.E.D. Indicators: 100 Mbps (Green), 10 Mbps (Yellow)
Power Supply: 2 x 12Vdc, 0.5Amps
Dimensions: L-3.55” x W-1.93” x H-1.0”,Color: Black, Mounting: Single Mounting tab with 3 holes
Network Data
Green, Yellow
Status L.E.D.’s
72-149 72-149

72-149-02212020-WB
Copyright CALRAD ELECTRONICS 2020All specifications subject to change without notice
Product Instructions
Page 2 of 2
RJ45 Green L.E.D. Status Indicator
RJ45 Yellow L.E.D. Status Indicator
Light On Light Off Light Slow On\Off
Power Saving
Power Off
Power On
Data Rate
100Mbs
100Mbs
Light On
Enabled
Enabled
Light Off
Disabled
Disabled
Light Blinking
Data Transferring
Data Transferring
All data connectivity settings between each 72-149
must match for connectivity to be established between them.
Auto-Negotiation Priority
Priority
3
1 (Highest)
4
6
2
5
7 (Lowest)
Mode
Long Distance 10Mbps
Long Distance 100Mbps
100BASE-TX Full Duplex
10BASE-T Full Duplex
100BASE-T1
100BASE-TX Half Duplex
10Base-T Half Duplex
Please refer to the chart below to
manually setup the Link Speeds and Modes
Auto Mode + EEE
Mode supports
Energy-Efficient-
Ethernet
Transmission Distance
Port/Cable Distance
RJ45 - Cat5e 500M/1640ft.
RJ45 - Cat5e 130M/425ft.
RJ45 - Cat5e 250M/820ft.
BNC - RG59 (75-3)
BNC - RG59 (75-3)
300M/984ft.
800M/2624ft.
RJ45 - Cat5e 300M/984ft.
RJ45 - Cat5e 800M/2624ft.
BNC - RG6u (75-5)
BNC - RG6U (75-5)
500M/1640ft.
1000M/3280ft.
Mode and Data Rate
Long Reach 100Mbps
100BASE-TX 100Mbps
10BASE-T 10Mbps
100Mbps
10Mbps
100BASE-T1 100Mbps
Long Reach 10Mbps
100Mbps
10Mbps
Blue Blinking Blue Blink Twice
Basic Troubleshooting
Status, L.E.D. Indicator
Blue Blinking
Status, L.E.D. Indicator
No Power: Verify DC Power (Power Supplies) are plugged
in and are producing 5Vdc on the coax power plugs.
No Ethernet Connectivity: Verify Power to both 72-149
units, check all Coax Connections check ethernet cables
and verify dip switch settings are correct. Check all L.E.D.
indicators are illuminated correctly. For additional Technical
Support, please contact Calrad at: 323-465-2131.
L.E.D. Staus Indicators
‘Best Plug & Play
Setting for
most Applications’
The transmission distance report below is based on the following: Comscope
57535-2 (Cat5e, 24Awg) cables and 75 ohm RG59 or RG6U coaxial cables.
Electronics
For technical assistance
call: 323-465-2131
CALRAD
R
Advanced Mode