Loading Negatives
Loading Slides
(2\
(1) -_(r,ry____-___-_______ (2)
(1) Hold up the negative toward the light. As you look through the nenegative,
(1) Hold up the slide toward the light. Fae the trademark stide ofthe slide
away from you. Look through the slide and it should appear nomally (not a
mirror image). Now turn the slide so the image is upside dom while lmking
at the same side.
(2) Open the slide holder at the marked spot on the top. With the stide hotder
laid open place the slide into reessed area in the holder - the slide
should lit perfectly.
Note: Handle slides with care. Any dust, Scratches orfinger prints will show
up on your saved images. lf possible, use cotton gloves wtren handing
slides. lt is recommended to use compressed air to remove any dust on the
slides. This is not included with the film senner but mn be purchased from
an office supply or electroni6 retailer.
you should be able to read the smail neg"tir" nurO"o io*"fiy t""i "
mirror image).
Now turn the negative so the image is upside down while looking at the
same side.
(2) Open the negative holder at the marked spot on the top. With the
negative holder raid open prace the negative into horder so the notches rine
up with the notches on the holder.
Note: Handle negatives with mre. Any dust, scratches or finger prints
will show up on your saved images. lf possible use cotto, gf;r"J*i*
nandting negatives. lt is re@mmended to use compressedlir to
remove any dust on the negatives,
This is not included with the tilm scanner but can be purchased from an
office supply or electronic retailers.
(4)
(3)
(4\
(3)
(3) Close the slide holder and press the edges so that it locks in place.
(4) Hold it in the position as showing the film smnner
lnsert the Slide Holder into the slot on the righl side of the film s€nner as
shown.
(3) Close the negativ€ holder and press the edges so that it locks in place.
Hold it in the position as shown in the film scanner.
(4) lnserl the negative holder into the slot on the right side ofthe flm
scanner as shown,
Film HoldeE: The design offilm holder is follow ISO standard. ln some @ses,
the holes on the film will not match exacdy to alignment ofthe holder. This is
caused by a non-standard camera. ln this case, there will be a small black line on
.^-the edge ofthe fEme that can easily be cropped out usihg photo editing software.
lsontemational Organization for Standardiation
