Camp Chef PRO 30 Assembly instructions

PRO 30
Model: SB30D
• One Universal Output (30,000 BTU/hr)
Cast Burners
• Systéme puissant á 1 brûleur de sortie universelle
• Detachable Legs
• Pattes amovibles
• Convenient 31” Cooking Height
• Hauteur du plan de travail de 78,7 cm (31 po)
• Appliance-style Temperature Controls
• Appareils de type Commandes de température
• Cloverleaf Cooking Surface
• Surface de cuisson Cloverleaf
STEP 1
Screw out thumb screws until flush with inside of
cooker leg. Apply extension to each leg. Hand tighten
thumb screws.
Stand cooker upright on solid level ground. To level:
loosen thumb screw on leg extension and adjust leg
height. Hand tighten thumb screw.
Do Not use stove without leg extensions.
STEP 2
Use an adjustable or 3/4” wrench to connect flare
fitting to stove fitting. Tighten securely with wrench.
DO NOT OVER-TIGHTEN.
Before attaching regulator to tank, ensure that all
valves are in the OFF position.
STEP 3
Attach regulator to tank. Check all connections to
ensure tightness. With all valves in the off position,
apply a soapy water solution to all fittings, valves and
connections. Turn gas on at the tank and check for
leaks at all connections. Small bubbles will appear if
connection leaks. Tighten as needed.
STEP 4
Turn on tank. Place a lit long nose lighter into round
lighting hole on cooker front. Turn valve knob to LOW.
Burner should light. If ignition does not occur in 5
seconds, turn the burner controls off, wait 5 minutes,
and repeat the lighting process.
REGULATOR
New Type 1 Connection: Right hand turn to connect
securely to New Type 1 tank.
TROUBLE SHOOTING
PROBLEM WITH FLAME?
(Flame should burn blue with a hint of yellow.)
Yellow Flame: Adjust air shutter open until burner
shows blue flame.
Still Yellow: Shut off valve(s) at stove and fuel tank.
Through air shutter opening, clean venturi (burner
neck) of obstructions such as cobwebs, dirt or bugs.
•Open Tank Valve Slowly
Small Flame: Flame will not adjust any larger... (Safety
Feature: New Low Pressure Regulator will detect a
sudden use of gas and automatically go into a “low
flow” mode and needs to be reset) Turn off all valves
at stove and at tank. Assure all fittings are tight and in
good repair. Test for leaks. Repeat steps 2, 3 and 4.
•Open Tank Valve Slowly
AIR SHUTTERS
(AIR VENTS)
Low Pressure
Burner
Quemador De
Baja Presión
Faible Pression
Au Bruleur
venturi
Tank Sold Separately
IMPORTANT INSTRUCTIONS ON ASSEMBLY AND SAFETY FOR YOUR CAMP CHEF COOKER
WARNING: Chemicals known to the state of California to cause cancer, birth defects, or other reproductive harm are created by the combustion of propane.
Sport Utility, Big gASS Grill, Keg Roaster, Ultimate Roaster Are From the Makers of Camp Chef and Covered Under One or More of the Following Patents: 356714, 378646, 417120, 328547, 358057, 364772
MAX POT DIAMETER 8”
ANSI Z21.89b-2012 CSA 1.18b-2012
KEEP FOR FUTURE REFERENCE
WARNING: Read Thoroughly
Before Use
DO NOT DISCARD THESE SAFETY INSTRUCTIONS
IF YOU SMELL GAS
1. Disconnect gas to the appliance.
2. Extinguish any open flame.
3. If odor continues, immediately leave the
premises and call your gas supplier or local
fire department.
FOR OUTDOOR USE ONLY
If stored indoors, detach hoses and leave
fuel cylinder outdoors, with valve closed and
plugged.
FUEL TYPE
This unit is designed for use with propane only.
No other fuel is approved for use with this unit.
FUEL CYLINDER
Always store fuel bottles in a safe outdoor
area with valve closed and plugged. Follow the
manufacturer’s recommendation for proper use
and storage of propane cylinders. Do Not Place
Propane Cylinders Directly Under Any Part of
the Burners.
CAUTION
Place the tank so as to minimize the possibility
of someone tripping over the connection hoses
while the cooker is set up. Never Lean Over or
Stand too Near the Cooker, or Allow Children or
Pets Near the Cooker During Use.
COMBUSTIBLE MATERIALS
During operation of cooker, insure proper
clearance from any combustible materials, in
relation to the top, sides and back of cooking
appliance. For outside use only. Do not use near
flammable walls or under eaves or overhangs
of homes or garages. Never leave unattended
while hot or in use. Allow cooker to cool before
take down and storage. The propane tank must
always be stored outdoors in a well ventilated
space. Never Stand or Lean Over Cooker Burner
While Lighting.
FOR YOUR SAFETY
Follow all safety, set-up, lighting and cooking
instructions. Do not store or use gasoline or
other flammable vapors and liquids in the
vicinity of this or any other appliance.
Regulator Model#
150/451
R329, RA329, RJ-A
JY70-003
JY95A7A
RYQF01

The manufacturer warrants stove components
(except paint and finish) to be free from
defect in materials and workmanship for 1
year from the date of purchase. All accessories
(included with stove or purchased separately)
are warranted from defect in materials and
workmanship for 90 days from the original
purchasing date. Within these periods, the
manufacturer will replace or repair defective
parts deemed unusable from its original intent
by making available the parts thereof FOB Hyde
Park, UT 84318.
Product paint and finish is not warranted. The
exterior finish of the product will wear down
over time. Touch up the exterior with black,
high temperature spray paint as needed. Do
not paint the inside surfaces.
Clean the unit after each use to maintain the
finish and prolong the life of your product.
Wipe away all grease and ashes. Keep metal
products free of moisture, salts, acids and harsh
fluctuations in temperatures.
Warranty does not cover normal wear of parts
or damage caused by misuse, abuse, verheating
and alteration. Repairs or alterations made by
anyone other than Camp Chef are not covered
in this Warranty. Manufacturer will not be held
liable for any losses due to neglectful operation.
Furthermore, this Warranty does not cover
damaged caused by natural disasters such as
earthquakes, hurricanes, tornadoes, floods,
lightning, fires, etc.
Upon the expiration of this warranty all such
liability will terminate. No other warranties are
expressed or implied.
Keep all original sales receipts. Proof of purchase
is required to obtain Warranty services. Prior
written approval and a Return Authorization
Number must be obtained. Returned items
will be accepted for repair or replacement
only. Returns must be shipped prepaid. Collect
shipment or shipments without a Return
Authorization Number will not be accepted.
*Warranty applies to the contiguous
US states only.
*LIMITEDWARRANTY
SB30D PARTS LIST
LP BURNER (1)
3-0808AL
AIR VENT(1)
3-0826L
LP SPRING (1)
3-0980
VALVE (1)
3-0997
KNOB (1)
3-330092
DEFLECTOR (1)
EX-1
MANIFOLD (1)
SL30-4
LP REGULATOR (1)
3-0835
1.25" LEG PLUG (8)
3-097110
LEG EXTENSION (4)
3-1046151/4 THUMB SCREW (4)
3-330076
SHELF (1)
1066FS
#8 SHELF NUT (1)
330029
#8 SHELF SCREW (1)
330028

How to Convert a Fire Pit,
Stove , &
Smoker to Natural Gas

NGKIT, which is our Natural Gas
Conversion Kit, is needed to
convert any Low Pressure Stove,
Smoke Vault, or Fire Pit.

Fire Pit Conversion to Natural Gas
Safety first! Make sure
everything is shut off and
that hose is removed
from propane tank.
Remove knob and valve
cover.
Remove valve from
burner, unscrew from
thermocouple wire, and
disconnect electrode
wire.
Once valve is
removed from fire
pit, drill the orifice
with a 1/8th drill bit.
Reassemble.

Stove Conversion to Natural Gas
Start by making
sure all is shut off
and that hose is
removed from
propane tank.
Remove knobs and
front panel. At this
point all you need
to do is remove
the manifold from
the valves..
Once valve is
removed from
burner, drill it’s
orifice with a #45
drill bit.
Reassemble.
NOTE: Only low
pressure stoves
(30,000BTU or
less) can be
converted to be
used with natural
gas.

Smoke Vault Conversion to Natural Gas
To convert the Smoke
Vault to natural gas you’ll
need the NGKIT and a #51
drill bit.
If you haven’t assembled
your smoker yet, remove
the valve from the burner
and use the specified drill
to widen the valve’s orifice.

If your smoker is
already assembled and
has been used, make
sure everything is
turned off and
disconnect the hose
from your smoker. Then
lay the smoker on it’s
back and remove the
burner. This will give
you access to the valve.
Drill valve’s orifice with
a #51 drill bit.
Check out the collection of camping we offer.