Candela GentleMax Pro User manual

INSTRUCTIONS TO GET TO LVM SCREEN
System: Candela GentleMax Pro
Laser Service Solutions 650 Grove Road, Suite 104 Paulsboro, NJ 08066
www.laserservicesolutions.com P: 856-853-7555 F: 856-853-7575
To get to the LVM screen on the Candela GentleMax Pro (GMax Pro), you will have to calibrate the laser
for the ALEX and YAG. If you know how to calibrate for both ALEX and YAG, proceed to step six for
instructions on how to go directly to the LVM and what information is needed by the technicians.
You can use whatever handpiece is available but our technicians recommend using a 15mm handpiece.
Step One: Turn key to power the GMax Pro laser and allow to warm up for at least 10 minutes.
Step Two: Your GMax Pro will default to either the ALEX or YAG main screen depending on which setting
you used before turning off the laser. In the center of the main screen will be a circular button and it will
say either ALEX or YAG. Your screen will also be a different color depending on the setting (ALEX is red,
YAG is green).
It does not matter which laser is calibrated first
ALEX SCREEN YAG SCREEN
Step Three: The ALEX and YAG have the same settings. Adjust and confirm that:
DURATION (LEFT BOX): 3ms
RATE (RIGHT BOX): 1.0 Hz

Laser Service Solutions 650 Grove Road, Suite 104 Paulsboro, NJ 08066
www.laserservicesolutions.com P: 856-853-8555 F: 856-853-7575
Step Four: Calibrate the laser
Press the down arrow button with the yellow “C” to start the calibration.
Your next screen will look like this. Confirm the
settings and press the check button.
This is your next screen. Again, press check button.
Your laser will now calibrate.
Step Five: Switch to the other setting, either YAG or ALEX depending on what you first calibrated.
Return to the main screen.
Press the center circle button marked either ALEX or YAG.
When pressed, it will switch to the other laser setting
depending on which laser you calibrated first.
REPEAT STEPS ONE – FOUR TO CALIBRATE

Laser Service Solutions 650 Grove Road, Suite 104 Paulsboro, NJ 08066
www.laserservicesolutions.com P: 856-853-8555 F: 856-853-7575
Step Six: Now that you have completed calibrating for ALEX and YAG, you can now go to the LVM
screen.
Return to the main screen. Press the button that looks like
a wrench on a file folder.
The next screen will look like this:
Press LVM button.
This is your LVM screen.
TAKE A PICTURE OF THIS SCREEN.
Next, press the magnifying glass tab.

Laser Service Solutions 650 Grove Road, Suite 104 Paulsboro, NJ 08066
www.laserservicesolutions.com P: 856-853-8555 F: 856-853-7575
This is your details screen.
TAKE A PICTURE OF THIS SCREEN.
Most importantly, the section
called “Efficiency” in the bottom
right corner.