Instruction manual DD935BK
Please keep this instruction manual for future reference
8
INSTALLATION INSTRUCTIONS
These instructions are for qualified personnel and are a guide for the installation
process, regulations and maintenance in accordance with the law and current
standards.
Before securing the hob to the worktop, ensure the downdraft has been assembled
as per the ‘Downdraft Assembly’ instructions on page 10.
POSITIONING
The hob is designed for either an inset or flush mounted installation, the way it is
illustrated in Fig.1. Apply the sealing strip (Fig.2) along the whole perimeter (for
dimensions of the cut out see Fig.1). Fix the hob into place with 4 fixing brackets,
keeping in mind the depth of the work surface (Fig.4).
If the lower part of the appliance is accessible after installation via the unit it is
installed in, it is necessary to mount a separating panel as shown in Fig. 4, keeping
in mind the distances stated.
VENTILATION
To ensure adequate ventilation, a 5mm gap below the worktop on the front edge
(see fig.3), should be applied.
If the product is being recirculated, a 5mm ventilation slot will also need to
be included in the kitchen plinth around the entire perimeter of the island.
Alternatively a vent grill can be installed onto the plinth in line with where the
motor has been installed to allow the clean air to escape back into the room.
DD935BK - Instruction manual.indd 8 28/11/2017 17:02
