CAPP CR-1730R User manual

Operation
Start / Stop
LED ON: Start/Run
LED OFF: Stop
Setting Speed
Touch once : RPM
Touch twice : RCF
Short Spin
Setting Time
To 99 min. 59 sec
or Continuous (00:00)
Set Value
Set time/speed
Program SAVE/CALL
Touch once: CALL
Touch twice: SAVE
(up to 100)
Setting ACC/DEC
ACC(1~9/Max. 9)
DEC(0~9/Natural DEC 0)
Lid Open
Open: LED turns on
AT SET SPEED
On : Counts the time at set speed
O󽗈 : Counts the time from starting
Temp/Fast Cool
-20℃ ~ 40℃,
Fast Cool
(fast temp function)
Display Screen
Status of Speed, Time,
Running, Lid Open/Close
Start / StopFunction Selection
Set value + Touch Enter button
Touch Function mode
PROG Save/CallFast Cool(fast temp)
Touch the button more than 2 sec Touch start/stop button
Touch once: CALL
Touch twice: SAVE
Set value
+ Touch Enter button
Display & Control Panel Quick Guide
HIGH SPEED REFRIGERATED CENTRIFUGE

CR-17-24 for 24 x 1.5 ㎖ / 2.0 ㎖ microtubes
CR-17-30 for 30 x 1.5 ㎖ / 2.0 ㎖ microtubes
CR-17-18 for 18 x 1.5 ㎖ / 2.0 ㎖ microtubes or 󽗉lter tubes
CR-17-5 for 12 x 5 ㎖ snap cap microtubes
CR-17-PCR for 64 x 0.2 ㎖ PCR tubes or 8 rows of PCR strips
CR-17-D8 for 8 x 1.5 ㎖ / 2.0 ㎖ microtubes
CR-17-D16 for 16 x 1.5 ㎖ / 2.0 ㎖ microtubes
Interchangeable rotors
Capp ApS ㅣ [phone] ㅣ [e-mail] ㅣ www.capp.dk
Check the rotor is installed correctly
and is sitting 󽗉rmly on the motor shaft.
Rotor checking
Clean the motor shaft.
Remove the foreign substances
not to cause any vibration.
Motor shaft & rotor
1
1
2
2
3
3
4
4
5
5
6
6
A A
B B
C C
D D
User 2017-01-12
설계자 점검자 승인자 날짜
1 / 1
에디션 용지
날 짜
Keep the instrument dry after use
for prolonged durability.
Take the rotor out and clean the
shaft with the dry soft cloth.
Keep the lid open after every use
1
1
2
2
3
3
4
4
5
5
6
6
A A
B B
C C
D D
User 2017-01-12
설계자 점검자 승인자 날짜
1 / 1
에디션 용지
날 짜
Precaution before Operating the Centrifuge
HIGH SPEED REFRIGERATED CENTRIFUGE
Load the sample tubes symmetrically.
Buckets or samples balanced
One step clicking action is enough to make a closure
of rotor lid.
Easy lock lid
Check the O-ring is put on the right place of
the rotor. Make the rotor lid loose when not
using the centrifuge which is for prolonged
durability of O-ring.
O-ring maintenance
O-ring