Car-Systems Rear-view camera Volkswagen Passat B8 User manual

www.carsystems.eu
Volkswagen Passat B8
v. 1.0.
Rear-view camera assembly manual
The bundle includes:
1 pcs camera built-in VW emblem
1 pcs drain pipe
1 pcs Plug&Play wire of 6,5m
1 pcs Coding manual

1
2
www.carsystems.eu
VW Passat B8 - rear-view camera - Assembly manual
2
Dismantle the rear trunk lid covering .
First remove the clamp holding warning
triangle.
Then loosen the locking tabs which are
indicated on the photo.
After the covering is loosened remove VW
emblem, screw the rear-view camera and
connect chips as shown on the photo.
A B
3
Pull the beam through the right side as shown
on the photo.

www.carsystems.eu 3
4
Next connect the yellow wire in charge of rear
light to the chip of internal lamp PIN number 7.
(black and blue wire) Dismantle the front and rear right door sill in
order to pull the beam through to the storage
side.
Rear door sill.
Front door.
B6
Start with dismantling the radio located
in the storage compartment on passenger's side.
Put the keys releasing locks in the place
indicated on the photo and disconnect chips.
YELLOW WIRE
PIN NO. 4
A
A
5
VW Passat B8 - rear-view camera - Assembly manual

B
www.carsystems.eu
4
7
After connecting all wires finish the assembly
and assemble everything in reverse order.
9
PIN NR 6PIN NR 6
PIN NR 12PIN NR 12 1122
+12V+12V
Connect wires for quadlock to the blue chip
8x0035447
Connect wire no. 1 to 12th socket in the chip.
Connect wire no. 2 to 6th socket in the chip.
Coding:
1.Using diagnostic equipment VCDS open
block 5F - Information Electr.
2.Find byte no. 19
3.Mark byte no. 4
In case the car is equipped with PDC system it
will be necessary to code PDC-10-Park/Steer
Assist module.
VW Passat B8 - rear-view camera - Assembly manual