Carax HUD CRX-3003 User manual

1.Vehicle speed display.
2.Speeding Warning.
3.GPS HUD can be wirelessly connected to mobile
devices such as PDA or Laptop computer through
Bluetooth.
4.GPS HUD also serves as a navigational satellite
receiver.
Installation
Adapter
DC12/24V > DC5V
Projection Sticker Tape
HUD main device Anti-slip pad
Speaker
Light source detect sensor
Function buttons
Power input connector
Projection panel
Package contents
GPS LED HEAD-UP DISPLAY Functions
1. Connect the power cable with the plug.
2. Connect the power cable with GPS HUD on the
mini USB end.
3. Plug the power cable into the cigarette lighter
socket of the car.
4. Once the power is on (or when the car starts),
GPS HUD will begin searching for the satellite
signal.The projection will show as follows:
HUD CRX-3003

7.Stick the reflecting film on the windshield where
the GPS HUD projects its image.
Stick the reflecting
film on the windshield
where the GPS HUD
projects its image.
Screen functions
Speeding warning sound
MPH mode
Km/Hr mode
Speeding warning sign(Red)
5. Fix the position of GPS HUD on the dashboard
for best viewing angle.
6.
Place the GPS HUD on the anti-slip pad.
Press button to turn on/off the speeding alarm
sound.
Head Up Display CRX-3003
Operating Voltage DC5V±5%
Adapter power in DC12~24V
Power Consumption 450 mA
Operating Temperature -20 C~85 C
HUD Dimensions 100.7mm X 91.4mm X 26.5mm
HUD Weight 90.5g
Speed Ranges 0~255Km/Hr
Max. Brightness 5500 nit
Display of driving speed green
Speeding icon red
Music icon orange
MPH, Km/Hr icon green
GPS Module
GPS Chipset SiRF Star III
Frequency 1575.42MHz (L1 band, CA code)
Channels 20-channel
Accuracy 2DRMS: approx. 10m
TTFF Cold start: 42s
Warm start: 38s
Hot start: 1s
Speeding Value Setting
There are 5 ranges of speeding value from 50, 70,
90, 100, 110 installed.
When the projection panel shows“70”after select,
it means the speeding value is 70.
value.
For example, if need to adjust the speeding
.
Press the button once will go to next set of
speeding value.
Displayed speed value adjustment
Press button twice to enter the setting mode of
This function mode is used for adjusting the
displayed speed value to agree with that of the
original dashboard. If the reading from the HUD is
value.
Press the button will leave setting mode, press
the button will go to next setting mode.