2
1
GENERAL SAFETY
WARNINGS
This manual is integral part of the cup
warmer it is supplied with.
Before proceeding with installation, use
and maintenance of the cup warmer,
the operator is held to read and fully un-
derstand the contents of this manual.
The cup warmer is intended for profes-
sional use. Always strictly follow the in-
structions contained in this manual and
keep it in a safe, dry place for future ref-
erence.
The weighted, equivalent sound pres-
sure level is below 48 dB.
After having unpacked the cup warmer,
verify its integrity. In case of damage or
doubts about the packaging content, con-
tact the Service Centre. Handle the cup
warmer with care to prevent the risk of
impacts or falls that may cause damage.
Keep packaging parts out of reach of
children since they are potentially dan-
gerous. Do not dump those parts into
the environment, but dispose them ac-
cording to applicable regulations.
Do not position the cup warmer in close
proximity of water jets or heat sources.
Avoid the direct contact with water or
other liquids also during cleaning. Do
not expose the cup warmer to weather
conditions.
Before plugging the cup warmer in,
make sure the power switch is on “0”
position. For electric safety of the cup
warmer, it is necessary to provide a
grounding system complete with a re-
sidual current circuit breaker (max IDN
= 30mA). Before connecting the de-
vice, make sure the data on the plate
correspond to the power mains.
The Manufacturer declines any liability
for failure to comply with the above or
for damages caused by the failure to
properly ground. Unroll the power cord
for its entire length to prevent the risk of
dangerous overheating.
The electric system must be equipped
with an omnipolar switch, in compliance
with the applicable safety regulations,
with contact opening gap and allowing
the complete disconnection in the con-
ditions of the overvoltage category III.
Unplug the cup warmer for any in-
tervention of routine maintenance or
checking. Do not pull the power cord to
unplug the cup warmer from the elec-
tric socket.
The use of the product is intended only
to professional operators who received
instructions concerning the appliance
safe use and understood the arising
risks. Children shall not play with the
cup warmer.
Never touch the hot parts of the cup
warmer.
Never touch the cup warmer when
hands or other body parts are wet. Nev-
er immerse the cup warmer in water.
The cup warmer is intended only for
the purpose set forth in this manual.
In case of fault or malfunctioning of the
cup warmer, switch it off and unplug.
In case of power cord damage, have it
replaced by the Manufacturer, his au-
thorized technical Service Centre or
skilled personnel to prevent any risk.
For repairing, contact only a Service
Centre authorised by the Manufactur-
er and require the use of original spare
parts and accessories. Failure to com-
ply with the above regulations could
jeopardise cup warmer safety.
For any communication regarding fail-
ures or malfunctioning, contact the near-
