CarLink CL-100 Service manual

1 / 2
Revision A: Changed Carlink Logo 2-12-04.
Dealer On-line Registration is also available http://www.satronics.com. Once you’ve accessed the web
page, click on on-line registration, fill in all fields required and submit.
NOTE: A dealer ID must be established before testing the product. Please complete the Authorized Dealer
ID Registration /Application Form and fax to the number shown on the form.
Test the units operation by: Dialing 1-800-495-7677 YOU WILL HEAR THE FOLLOWING INTRODUCTION
WELCOME TO YOUR VEHICLE COMMAND CENTER FOR ENGLISH PRESS (1) FOR CUSTOMER COMMANDS.
PRESS 1 FOR DEALER TESTING OF STAND-ALONE PAGING PRODUCTS. PRESS 2
FOR DEALER TESTING OF ALARM PRODUCTS. PRESS ((3)
PLEASE ENTER YOUR DEALER ID, (XXXX), FOLLOWED BY THE # SIGN PLEASE ENTER YOUR PIN NUMBER,
(XXXX), FOLLOWED BY THE # SIGN PLEASE ENTER THE SERIAL NUMBER TO BE TESTED, FOLLOWED BY THE #
SIGN SELECTION OF VOICE PROMPTS FOR FEATURE TESTING ARE LISTED BELOW:
1. COMMANDS

VPI Commands Alarm Response
1 Arm alarm 1 light flash - 1 siren chirps
2 Disarm alarm 2 light flashes - 2 siren chirps
3 Door unlock Door Unlock
4 Carjack/Theft Full Trigger
5 Alarm reset Reset (Armed mode)
6 Car Finder 1 light flash every 5 seconds for 3 minutes
7 Aux 1 output Aux1, 1second (-) pulse output
2 / 2