Music Server connections
Connect the network cable
1
If your matrix amplifier is controlled using
RS-232 (serial), then plug in and connect
the usb-to-serial cable from your music
server to the control port on your matrix
amplifier
2
Connect Stream 1 (using the analog 3.5
mm to RCA audio cable) to your matrix
amplifier
3
Now follow the QuickStart Guide for your
matrix amplifier to connect your music
server with your matrix amplifier
5
QuickStart Guide
CasaTunes CT-1/2 Music Server
For a CT-2, plug in the USB Audio adapter
and connect Stream 2 (using the analog 3.5
mm to RCA audio cable) to your matrix
amplifier
4
Use this guide to quickly setup and configure your
CasaTunes music server by following these steps:
Unpack and verify system contents
Connect the music server power, network,
control and audio cables
Use the CasaSetup browser application to
configure your system
Optionally setup your music server to use WiFi
1.
2.
3.
4.
Use this guide in conjunction with the QuickStart
Guide for your matrix amplifier to setup your
system
1 x CT-1/2 CasaTunes music server
1 x USB Audio Adapter (CT-2 only)
1 x Power adapter
1 x Network cable
1 x USB-to-serial cable*
1 x 3.5 mm stereo to RCA audio cables (2
for CT-2)
What's in the box?
*Replaced with an extra network cable when server is shipped
with a CT-5X4MA or CT-12X8MA matrix amplifier