Castleton ZH1292 STORAGE LOUNGE User manual

For assistance with assembly contact:
Wayfair Customer Service,
877-WAYFAIR (877-929-3247)
www.wayfair.com
Page 1
ZH1292 STORAGE LOUNGE
-GREY MICRO
ZH1292 STORAGE LOUNGE
-KHAKI MICRO
Assembly Instructions

A Quantity
of 1
Seat
B Quantity
of 1
Back panel
CQuantity
of 1
Side panel
DQuantity
of 2
Front legs
EQuantity
of 2
Back legs
EQuantity
of 1
Pillow
1 Quantity
of 12
Bolt:5/16”* 2-3/8”L
2Quantity
of 12
Spring washer
3Quantity
of 12
Flat washer
4Quantity
of 1
Allen wrench
Care and Cleaning Instructions:
Please see care and cleaning label attached to bottom
of chair seat.
For replacement parts or questions, please
call Customer Service at 877-WAYFAIR
(877-929-3247)
Page2
ZH1292 STORAGE LOUNGE
Parts List
Before beginning assembly, separate all parts and carefully study the parts diagrams below.
Review all parts and hardware before disposing of any packaging.
You may receive extra hardware with your unit.
Call Customer Service for missing hardware.

.
Figure 1
Unpack and lay parts on clean,
padded surface like carpet or
blanket. Check that you have all
parts indicated on the front page.
Open the Seat’s (Part A) cover
and keep the Seat’s (Part A) cover
open.
Figure 2
Attach Back panel (Part B) to Seat
(Part A) by bolts (1) and Spring
washer (2) and flat washer(3),
Tighten them by using Allen
wrench (4) as shown in Figure 2.
Page 3
ZH1292 STORAGE LOUNGE
Assembly Instructions
A
B
1
2
3
1
2
34
A

Figure 3
Attach Side panel (Part C) to Seat
(Part A) and Back panel (Part B)
by bolts (1) and Spring washer (2)
and flat washer(3), Tighten them
by using Allen wrench (4) as
shown in Figure 3.
Figure 4
Lift the Velcro strip from the Side
of side panel (Part C)
Insert bolt (1) and Spring washers
(2) and flat washers (3) into
inside pre-drilled holes, tighten
bolt (1) by Allen wrench (4) as
shown in figure 4.
Then close Velcro strip on the side
of side panel(part C)
Page 4
C
A
B
A
B
123
4
C123
4
1
2
3
4
C
B
A

Figure 5
Attach front Legs (Part D) into the
seat (A) by hand rotating and
attach the back leg(part E) to
Back panel (Part B)’s pre-drilled
holes by hand rotating, Tighten
them by hand as shown in Figure
5.
Figure 6
Turn over the lounge,
Then place the Pillow on the
lounge as shown.
Now your lounge is ready to use!
Page 5
A
C
D
EB