CEL-FI TELSTRA GO Mobile User manual

7Installation Process
6Tips & Tricks
For more information, visit: www.cel-.com
TELSTRA GO Mobile
Quick Start Guide
Smart Signal Repeater
TELSTRA GO is an evolved cellular repeater
design that can amplify cellular signals up
to 70dB. Connect a single Donor External
Antenna to receive the macro-network signals,
and then a single indoor Service Antenna
where you need service, and TELSTRA GO will
do the rest automatically.
IN THE BOX
• TELSTRA GO Mobile Repeater
• Quick Start Guide • Donor & Service Antenna
• Warranty Card • Screws
Copyright © 2017 by Nextivity, Inc, U.S. Patents pending. All rights reserved.
The Nextivity and Cel-Fi logos are registered trademarks of Nextivity Inc. All
other trademarks or registered trademarks listed belong to their respective
owners. Designed by Nextivity Inc in California. qsg_GO-Mobile-Telstra-Eng_17-0609
• Keep Donor and Service Antennas separated/isolated
from each other for best performance
• For best performance, the cable between the Outdoor
Antenna and GO unit should be as short as possible
• Use sealant if any connections are exposed to
elements
For more TELSTRA GO features, go to App Store or
Google play and download the mobile Cel-Fi WAVE app.
(NOTE: If you do not have a compatible smartphone, go
to cel-.com/wave to download the Desktop app.)
NETWORK STRENGTH
The Cel-Fi WAVE app can help you
optimize your system’s performance.
TELSTRA GO Mobile Smart Signal Repeater www.cel-.com

Install Service Antenna
2
For best performance make sure
there is 50cm of metal around the
base of the antenna.
Mount your Donor Antenna on the exterior of the
vehicle, towards the rear, according to its design, and
the type of vehicle it’s being used with. Make sure you
consider the cable connection to the TELSTRA GO
unit with your location choice.
Install Service Antenna in the cab, towards the front,
where coverage is needed. Ideally, there should be
substantial material, like the metal of the roof, between
the Donor and Service Antennas, to improve isolation.
DONOR ANTENNA (Not Included)
Install Donor Antenna
I
SERVICE ANTENNA
(Not Included)
DONOR ANTENNA
TELSTRA GO Mobile Installation
3Mount TELSTRA GO
Find a good mounting location in your vehicle. Location
should have airow and be secure from contact with
external objects.
Make sure the unit is within cable range of the 12V power
supply on your vehicle.
Best to make sure all cable lengths support the intended
mounting location BEFORE permanent mounting.
DO NOT plug in at this time.
TELSTRA GO
OPTIONAL
LOCATION
DONOR ANTENNA
TELSTRA GO
SERVICE
ANTENNA
4Connect Donor & Service Antennas
to the TELSTRA GO Unit
LEFT SIDE:
Service Antenna Connector
RIGHT SIDE:
Donor Antenna Connector
DONOR ANTENNA
TELSTRA GO
TOP VIEW
STATUS
INDICATOR
MODE
SERVICE
ANTENNA
5Plug in TELSTRA GO & Select Mode
(*NOTE: if Error, go to troubleshooting
at cel-.com/support)
AUTO
3G
4G/4GX
MODE
SELECT
BUTTON
MODE
STATUS
INDICATOR
Boosting 3G
Boosting 4G/4GX
Error*
STATUS
INDICATOR
12V POWER SUPPLY
DONOR ANTENNA
TELSTRA GO SERVICE
ANTENNA
TELSTRA GO Mobile Smart Signal Repeater www.cel-.com
Press the MODE button on the unit to select desired
scanning mode. Status Indicator will blink during the
setup process, and may take a few minutes to complete.
(OPTIONAL: use your smartphone to select
mode. Download the Cel‑Fi WAVE app, and
follow the on-screen instructions.)
NETWORK STRENGTH