Cerio ANT-12A User manual

Installation Guide
5Ghz Outdoor Omni 12dBi with 1M N-Plug to N-Plug NFC200 Low Loss RF Cable Pole / Wall Mount Antenna
1
CERIO Corporation
ANT-12A
5Ghz Outdoor Omni 12dBi
with RF Cable Pole / Wall Mount Antenna
Installation Guide
Technical Support
E-mail: [e-mail]
TEL: [phone] #222
Web Site: www.cerio.com.tw

Installation Guide
5Ghz Outdoor Omni 12dBi with 1M N-Plug to N-Plug NFC200 Low Loss RF Cable Pole / Wall Mount Antenna
Package Contents :
ANT-12A Main Unit x1
Pole & Wall Mounting Ki x1
RF Cables (NFC-NNP-1M) x1
Quick Installation Guide x1
Warranty Card x1
Main Unit Overview : (ANT-12A)
RF Cable Overview : (NFC-NNP-1M)
N Connect

Installation Guide
5Ghz Outdoor Omni 12dBi with 1M N-Plug to N-Plug NFC200 Low Loss RF Cable Pole / Wall Mount Antenna
3
Installation:
1. Mount the antenna on the brackets according to the Mounting diagram. Make sure
the horizontal omnidirectional of the ANT-12A antenna with a beamwidth (H plane)
of 360  and a beamwidth (E plane) of 12 .
2. Mount the ANT-12A antenna on the antenna on the mast supplied by customer
according to the Mounting diagram.
3. Test the antenna with equipment to make sure the antenna receive the best signal first,
then lock all the screws and seal the connector between ANT-12A antenna and NFC-NNP-
1M RF cables with a waterproof cap.
No Surge arrester installation
Installation using a Surge arrester

Installation Guide
5Ghz Outdoor Omni 12dBi with 1M N-Plug to N-Plug NFC200 Low Loss RF Cable Pole / Wall Mount Antenna
NO DESCRIPTION QTY NO DESCRIPTION QTY
1
L Bracket
1
7
Lock washer
1
2
Pole-clamp
1
8
HEX. Nut
1
3
1/4” U-bolt
1
9
Plastic wall plug
2
4
Flat washer
2
10
M4 flat washer
2
5 Spring washer 2
11
5/32" Self tapping
screws screws
2
6
1/4” Wing nut
2
mm
(in)
ANT-12A
NO.3 Available Pole Range│Ø20-Ø52mm
If equipped with Surge Arrester
1. Pole Mount (Pole Range: Ø40-Ø50mm)
2. Alternative wall mount
Drill 2 holes on the wall with following dimensions.
ANT-12A
The product does not include Surge Arrester ,
The Surge Arrester ( model : LP-300) is by optional.
ANT-12A
Pay attention to the installation location
The antenna radiation would be
interfered if the metal pole and
antenna overlap too much.
Caution:
Pay attention to spacing
The antenna installation distance must
be greater than 50cm, otherwise it will
cause signal interference.