Cetacea Sound Orbiter Pod User manual

Quick Start Guide
Orbiter Pod
MICROPHONE + CEILING RECEIVER

Orbiter Transmitter
FRONT
BACK
Orbiter Ceiling Receiver
LINE OUT
POWER
Green LED
PAIRING HOLE
WIRELESS
CONNECTION
Amber LED
MASTER
CONTROL
ON/OFF/MUTE
VOLUME
CONTROL
STATUS INDICATOR
Green LED
FRONT
SIDE A SIDE B
DC IN
PAIRING HOLE
REFERENCE IMAGES
© 2018 Cetacea Sound Corp.All rights reserved. Orbiter™ is a trademark of Cetacea Sound Corp. 1(800) 556-1922 [email protected] www.cetaceasound.com All audio products are proudly made in the U.S.A.

PRIOR TO OPERATION
Please allow two hours of charge prior
to first use.
1. Connect the charger to the power connector on the Orbiter.
2. Green LED will begin flashing.
3. Allow for two hours of charge time prior to first use or
when Green LED is glowing steady.
2
CONNECT ORBITER TO CHARGER
CHARGE UP ORBITER
TRANSMITTER
➊
➋
READ BEFORE
INSTALLING
For in-depth safety, installation,
and operational procedures, read or
download the Orbiter Owner’s Manual
at www.cetaceasound.com.
ORBITER™SYSTEM CONTENTS
Orbiter Transmitter Orbiter Ceiling Mount Receiver
Receiver Power Supply
Transmitter Charger
Lanyard Kit
LINE OUT
PAIR
3’ Audio Cable
NOTE
The Orbiter has built-in overcharge protection.
Once fully charged, the Green LED will cycle
between charge (steady) and discharge (blinking).
Mounting Kit
Triplex AC Adapter

INSTALLER NOTES
No tools are required to set up the
Orbiter other than to run cable as
needed. Clips, hangers, and hooks are
recommended for long cable runs.
INSTALL RECEIVER ON CEILING NEAR AN AC SOURCE
SET UP AND CONNECT
RECEIVER
CONTROLLING FEEDBACK
When operating the Orbiter for the first
time, step away from the speaker and be
ready to adjust volume down as needed.
Have a second person help determine
appropriate loudness by listening from
the audience location.
OPERATE THE ORBITER
TRANSMITTER
REMOVE ORBITER FROM CHARGER PRIOR TO USE
3. Amber LED will illuminate on the receiver while connected.
4. Set appropriate volume with VOLUME CONTROL button.
1. Click MASTER CONTROL once for ON.
Click again to cycle between ON and MUTE. To
turn OFF, push and hold MASTER CONTROL for 4
seconds, then release.
2. Green LED will illuminate on the transmitter while ON.
➊
➍
LINE OUT
DC OUT
PAIR
Astronaut Speaker (not included)
NOTE
The Orbiter will not connect to the receiver while charging. Once
charged, disconnect charger and operate pendant as normal.
DC IN LINE OUT
Side A of ReceiverSide B of Receiver
Power Supply 3.5mm Speaker Cable
LINE OUT
PAIR