Cetacea Sound ASTRO-LR-001 User manual

The ASTRONAUT can be mounted to most ceilings. Locate it at least 4 feet from
the nearest wall or vertical obstruction. It does not need to be mounted in the
center of the room.
This Model LR-001 includes a wall mount power supply that can be plugged
into an available AC Outlet and a 40' cable which can be used as is or cut to the
desired length. This part number includes a special wall mount power supply
(FW-15WCL) with screw terminal type lugs to t the Cetacea long run 40' power
cable (AB-125SL).
There are two other styles of power supplies available for this product: the wall
mount supply (FW-PSE12W) has an attached 9' (2.5m) cord, and the desk top
supply (FW-PSE12DL) has a 6.5' (2m) removable AC cord and a 6' (1.8m) attached
low power cord for a total reach of 12' If needed, they can be ordered separately
under their own part numbers.
The Astronaut is capable of lling 2,000 square foot rooms with highly intelligible
and distortion-free sound when mounted correctly. See information below and
on our web site, www.cetaceasound.com. The complete Fact Sheet is on the
Literature Page.
WARRANTY
Do not disassemble or modify the Astronaut speaker. Removing the bottom
cover or other components will invalidate the warranty. The standard
Astronaut warranty is two years from the date of purchase. Please see our
Warranty Statement on our website for complete information.
LIMITED LIABILITY
Cetacea Sound Corp assumes no liability for the use of unapproved brackets
or other unapproved installation methods.
READ THESE INSTRUCTIONS CLOSELY 200901-003
ASTRONAUT
Quick Start Guide
Model #: LANDER LR-001
(Long Run Power Supply
& Cable, USA Only)
TWIST
INPUT A B C DCPWR

ASTRONAUT CEILING INSTALLATION
READ THESE INSTRUCTIONS CLOSELY
Power
1) Do not plug the power transformer into the wall outlet until after the long
run cable is attached as follows: black wire is Ground (-) and white wire is
Positive (+).
2) Do not plug the power cable into the Astronaut until after all source and power
connections are made. The power cable connector is the on-off switch and
if there is not a source cable attached to the speaker, the speaker may emit
loud undesirable noises. Plug in a source, like a DVD, projector or personal
computer rst and then plug the small 5.5mm barrel connector of the power
supply cable into the base of the speaker where indicated. It will only t in
one location.
Source
3) There are 3 mini-jack (3.5mm) inputs on the speaker for accepting multiple
sources of sound. They accept either mono- or stereo jacks and content.
4) Make sure the volume is turned down to an acceptable level before turning
on the source. The Astronaut does not have any internal volume control.
Therefore the volume is controlled by external means from the DVD, VCR, PC,
or projector. External volume controls like mixers and some wall plates can be
used to control volume also.
5) Once source inputs are connected and the power supply cable is connected,
turn on the sound. Be sure to use a high quality recording to fully appreciate
the Astronaut’s awesome performance. Once you are satised with the sound,
notice the source volume level so you can repeat this same sound stage with
the audience in the room. The larger the audience the better it sounds!
In order to obtain maximum enjoyment from this exciting new audio system, visit our
web site and print copies of our application guides, room drawings, hook-up drawings
and spec sheets to learn how to make a lasting impression with your audience.
The spec sheet for this product is labeled LR001 on our literature page.
200901-003
If you have questions, call Technical Support at 800-556-1922.
www.cetaceasound.com