CF MOTO 5HY0-805100-1000 Parts list manual

ITEM PART NAME PART NUMBER QTY. REMARK
1 HEATED DRIVER SEAT ASSY 5HY0-805100-1000 1
The image below is not
the nal product.
2 HEATED DRIVER SEAT 5HY0-131200-20000 1
3 BRACKET, HEATING SWITCH 5HY0-130001 1
4 SEAT HEATING SWITCH 5HY0-136000 1
5SELF-TAPPING SCREW ST4.8×13 30110-480130010 3
6 TIE BAND 8010-150003 1
ACCESSORY SETUP INSTRUCTION
BEFORE YOU BEGIN: Read and understand the instructions before starting any work. Make sure that all parts are
ready and that you have all the tools required for assembly.
NOTE: CFMOTO shall not be liable for any damage caused by incorrect assembly. CFMOTO recommends that all
original accessories be assembled by an authorized CFMOTO dealer.
Before assembly, park the vehicle on a at surface, put the transmission gear into Park (P) and turn off the key switch.
Zhejiang CFMOTO Power Co., Ltd. All rights reserved. Reproduction of this document, even in part, as well as copying of all kinds, is
permitted only with the express written permission of the copyright owner.
!
MEANING OF SYMBOLS
- Indicates information with more details or tips.
- Indicates information of warning or danger.
i
PARTS LIST:
HEATED DRIVER SEAT ASSY-- PN 5HY0-805100-1000
VALID FOR: MY2019 and Newer UFORCE 1000 UTVs
ITEM DESCRIPTION QTY. REMARK
113mm ALLEN WRENCH 1
Recommended tools2 PROTECTIVE GLOVES 1
3 CUTTER 1
TOOL LIST:

2
∥Remove the driver seat assy (A).
∥Place the driver seat assy (A) on a protected stable
work surface and remove the bolts (B) shown.
B
A
∥Turn the handle (C) to adjust the seat base position,
creating access for removal of the remaining upper
bolts (B).
B
2
∥Position the heated driver seat (2) in the assembly
position. Install the removed bolts (B) to secure it,
using caution not to over-tighten them.
B
A
C
ASSEMBLY and INSTALLATION

3
∥Remove the seat left lower guard (D)
E
D
∥At the front of the lower deco panel, use a cutting
tool to remove the cut-out (E) as shown under the
seat. Use extreme caution to prevent damage to the
surrounding plastic.
5
4
3
5
5
F
∥Place the seat heating switch (4) into the opening
made under the seat, then secure it with the heating
switch bracket (3) and self-tapping screws (5).
∥In the vehicle, locate and remove the white plug from
reserved port (F) as shown.
ASSEMBLY and INSTALLATION

4
H
F
I
J
D
∥Connect port (F) to port (G) of the seat heating switch.
G
∥Connect the seat switch port (H) to the seat heating
port (I), and secure them with tie band (6) as shown.
6
∥Position the heated driver seat cable (J) as shown in
the image and install the seat left lower guard (D).
∥Install the heated driver seat and ensure it is latched.
ASSEMBLY and INSTALLATION