5
DRAINAGE
While the water tank is full, the compressor will stop and the water full indicator light will
illuminate.
To remove the water tank, pull it out carefully from the unit.
After empting the water tank, place the tank back to the unit. Make sure it is properly
positioned, in order for the water full indicator light to go out and your dehumidifier is
operating.
Please note, in case, the water tank has not been positioned well, the water full indicator
light will still illuminate.
CONTINUOUS DRAINAGE
When the dehumidifier is operated at very high humidity levels, the water tank will require
more frequent drainage. In this situation, it may be more convenient to set the unit up for
continuous drainage with the following procedures:
1. Remove the water tank from the unit.
2. Remove the rubber water stopper in the continuous drainage port. Keep the rubber
water stopper in a safety place for future use.
3. Remove the plastic cover carefully at the back of the unit.
4. Prepare the water tube (not included) with 13.5mm internal diameter and 1.5mm
thickness.
5. Insert the tube through the hole at the back to the front.
6. Connect the tube to the continuous drainage port.
7. Put the water tank back to the unit.
8. Ensure the water will always drain away freely and the tube will remain in right place &
the water tank is in correct position.
NOTE : In very cold weather conditions, precaution should be taken to prevent the water
tube from freezing.
If it is no longer to use the continuous drainage, please follow the below procedures :
1. Remove the water tank from the unit.
2. Remove the water tube from the continuous drainage port. Then pull it out from the
hole at the back of the unit.
