Champion USN-72 User manual

Complete the information below for quick reference.
Model Number Serial Number
Voltage and Phase
Factory Authorized Service Centers and Marine Products Installers
Headquarters San Diego Office Mayport Office
The Source The Source The Source
502 Rotary Street 616 Marsat Court 41 West 6Th Street
Hampton, VA 23661 Chula Vista, CA 91911 Atlantic Beach, FL 32233
Tel: [phone] (619) TBD [phone]
[phone] [phone] [phone]
Fax: [phone] [phone] [phone]
Website: www.thesource2000.com Email: [e-mail]
Equipment information - Darlene Ehrenfried [e-mail]
Parts information HQ– Samantha Johnson [email protected]m
Service information HQ – Jim Luther [email protected]
U. S. Navy POC – Judy Lowman [email protected]
U. S. Navy POC – Ken Height, San Diego [email protected]
U. S. Navy POC – Tony Cox, Jacksonville FL [email protected]m
Please call for your Authorized- NSU Warranty Start up today!
Machine Data Plate with
Model & Serial Number
located on left front
corner of the lower panel

TECHNICAL PUBLICATION SHEET
i
TECHNICAL PUBLICATION SHEET

TECHNICAL MANUAL VALIDATION CERTIFICATE
ii
TECHNICAL MANUAL VALIDATION CERTIFICATE

APPROVAL AND PROCUREMENT RECORD
iii
APPROVAL AND PROCUREMENT RECORD

TECHNICAL MANUAL DEFICIENCY/EVALUATION REPORT (TMDER)
iv
TECHNICAL MANUAL
DEFICIENCY/EVALUATION REPORT (TMDER)
(Form - NAVSEA 9086/10, REV. 6/85)

REVISION RECORD
Revision Revised Serial Number Comments
Date Pages Effectivity
4/29/98 All 90922 First Issue of Manual and replacement
parts lists
3/16/00 All J1050 Added electric tank heat to and
revised chain tensioner
3/9/01 58-59 J1051 Added end panels, front panels,
revised leg assy
3/9/01 60-61 J1051 Revised tank fill piping assy
3/9/01 62-63 J1051 Revised final rinse piping assy
3/9/01 66a-67a J1051 Revised track and guide assy
3/9/01 68a-69a J1051 Revised chain tension assy
3/9/01 70-71 J1051 Added end panel
3/9/01 86-87 J1051 Revised drain assy
3/9/01 90-91 J1050 Revised control cabinet
3/9/01 90a-90b J1051 Revised control cabinet
3/9/01 94-102 J1080 Added MRAN 90°
3/9/01 104-107 J1080 Added CH-60 Electric Booster
(For USS RAmage Only)
2/27/02 61,63 J1534 Added new vacuum breakers and kits
2/27/02 71 Replaced P/N's 112606 and 112607
with new part numbers 113398 and
113399.
4/8/02 102 Corrected spacer number for bubble 16
to 15.
103 Corrected part number 111064 to
111603 and 111605.
Corrected motor clamp from 314351 to
325622.
4/30/02 71 Replaced part number 112608 and 112783
with 110164.
Added V-belt 100795.
7/31/02 67, 67a J1616 Replaced part number 112708 with part
part numbers 900840 and 113509.
1/20/03 Front Cover Added APL numbers.
1/21/03 10,11 Corrected connection points from 3/4"
to 1/2" on hot water supply lines to
dishwasher connections.
1/23/03 20 Added prime switches to drawing and
control functions.
REVISION RECORD
v

REVISION RECORD (CONT.)
Revision Revised Serial Number Comments
Date Pages Effectivity
1/23/03 88, 89 J1698 Added P/N 109069 control thermostat.
6/23/03 91, 91a Revised part number for selector switch.
8/13/03 59 J1589 Revised P/N 317331 to 325351.
8/13/03 60, 63 Revised plastic style vacuum breakers
with bronze style.
8/14/03 85 J1332 Revised P/N 111841 to 112379 and
112338 pump flange with gasket.
8/14/03 92-93,92a-93a Inserted new replacement kits for
92b-93b selector switches, pushbuttons, lighted
switches
8/14/03 93,93a,93b Replaced Furance (Siemens) overloads
with Telemecanique (Square D) .
11/6/03 11, 13, 14-16, J1872 Insert new junction box location and
21 installation information.
11/6/03 76b, 77b J1872 Inserted new pages for terminal block
and strip drawing and parts.
11/06/03 82a, 83a J1872 Inserted new pages for wash and rinse
tank junction boxes drawings and parts.
11/06/03 J1872 Inserted new schematics and intercon-
nection drawings.
vi
REVISION RECORD
10/13/04  58, 59 J1921 Inserted additional curtain and curtain
rods in between wash and rinse tanks.
3/16/05 101 Corrected part number for item 8 from
208386 to 202381. Inserted note for
crank direction.

vii
THIS PAGE
INTENTIONALLY
LEFT BLANK

SAFETY SUMMARY
viii
SAFETY SUMMARY
General Safety Rules
• The following general safety rules must be observed in addition to the specific cautions and warnings
presented in this manual.
• Your Champion dishwasher is a heated machine using very hot water to clean and sanitize a variety of
wares. Machine surfaces and wares become hot during and immediately following normal operations.
Consult your supervisor and wear protective gear as directed to avoid possible injury.
• Your dishwasher contains moving conveyor parts.
Use caution when working around the dishwasher especially when loading or unloading wares.
• Operators must NOT bypass a safety interlock or control to operate the dishwasher.
• The service and maintenance instructions contained in this manual are intended for qualified service
personnel. These instructions assume that you are trained in basic electricity and mechanical theory. If
you are not a trained technician, then do not attempt to adjust or repair the dishwasher as serious
personal injury or damage to the dishwasher may result.
Safety Symbols
• The following symbols appear throughout this manual alerting you to potential hazards.
Statements associated with each symbol are printed in italics.
!CAUTION:
Caution statements indicate any condition or practice which,
if not strictly observed or remedied, could result in damage to
or destruction of the dishwasher.
WARNING:
Warning statements indicate any condition or practice that
could result in personal injury or possible loss of life.
NOTE:
Note statements indicate any condition or practice which,
if observed, will help in the safe completion of a task.