
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should always be followed,
including the following:
1. Read all instructions carefully.
2. Do not touch hot surfaces. Always lift by handle.
3. To protect against fire, electric shock and injury to persons, do not immerse cord, plug, Hot Pot™
or power base in water or other liquid.
4. Close adult supervision is necessary when any appliance is used by or near children, handicapped
persons or the infirm.
5. Always unplug the power base when not in use in order to avoid accidental electrical shock.
Allow the Hot Pot™to cool before cleaning.
6. Do not operate with a damaged cord, or plug, or after a malfunction has occurred or the Hot Pot™has
been damaged in any manner. Return Hot Pot™to the EdgeCraft Corporation, Service Department for
examination, repair or adjustment.
7. The use of accessory attachments not recommended by the EdgeCraft Corporation may result in fire,
electric shock or injury to persons.
8. Do not use Hot Pot™outdoors.
9. Do not let power cord hang over edge of table or counter or touch hot surfaces.
10. Always place the Hot Pot™on the base before plugging in the base or turning on power. After use turn
power switch to off position or make sure it has switched off automatically before attempting to unplug
Hot Pot™base.
11. Do not use this Hot Pot™or the power base for other than intended use.
12. Do not attempt to plug any device other than designated Hot Pot™into the power base.
13. Do not place on or near hot gas or electric burner or in a heated oven.
14. Do not operate Hot Pot™unless lid is fully closed.
15. Never fill Hot Pot™while it rests on the power base.
16. Do not turn power on unless Hot Pot™contains sufficient water.
17. CAUTION: Unplug IMMEDIATELY if water spills onto bottom of Hot Pot™, onto power base or into
connector, to avoid electrical shock.
18. CAUTION: To avoid the risk of being scalded never fill Hot Pot™above the “MAX” line shown on the water
level gauge. For the same reason, extreme caution must be used when moving an appliance containing
hot water or other hot liquids. Always pour slowly and carefully.
19. Only operate Hot Pot™on a dry, flat, non-slip surface.
20. For household use only.
SAVE THESE INSTRUCTIONS
Made a Good Choice!
YourChef’sChoice®Cordless Electric Hot Pot is the best of its kind. It can efficiently boil 1.6 quarts of water in only
minutes. An appliance crafted for excellence, careful attention has been given to every detail from the sleek design to
the triple protection safety switches. No detail has been overlooked.
A convenient external water gauge lets you know the water level even when the lid is closed.
TheHotPot’senclosedheatingelementsallowsforaneasilycleanable,seamlessstainlesssteelinteriorandinsures
years of service from this elegant yet durable product.
Please take a minute to familiarize yourself with the following instructions to maximize your enjoyment of your Hot Pot.
First Use of the Hot Pot
•ReadallsafetyandoperatinginstructionscarefullybeforeusingtheHotPotforthersttime.
•ForbrandnewHotPots,donotusetherstllingofboiledwater,discarditandrinseouttheHotPotwithcold
water, after the Hot Pot has cooled down.
Using Your Chef’sChoice®Hot Pot
•Theappliancehastwoparts:
a) Base unit with electrical connector and power cord
b) Detachable Hot Pot with electrical adaptor.
•TheHotPotcanonlybeusedwiththeappropriatebaseunit.BaseunitandHotPotmustbearthesamemodel
number. The Hot Pot lid is equipped with a safety lock so that it does not open unintentionally while the water is
being poured. The lid can be easily opened with one hand. Simply grasp the handle and pull back on the lid lever
with the thumb.
•Toclosethelid,pressdownlightlyonituntilitsnapscompletelyshut.
•RemoveHotPotfromthebase.FillHotPotwithnotlessthenonecup(0.2liters)ofwatertopreventitfrom
running dry during the boiling process. Do not fill the Hot Pot above the maximum line shown on the water gauge,
to prevent boiling water from splashing out through the spout. If overfilled and water flows down outside of
Hot Pot and onto its bottom, disconnect the power cord from the power outlet, empty pot, dry base and refill
Hot Pot carefully before setting onto base unit. Water on the bottom of the Hot Pot can lead to an electric shock
(see further instructions.)
•Afterllingwithwater,placetheHotPotonthebaseunit.
•TheHotPotisequippedwithaconvenientautomaticswitch-offdevicewhichdeactivatestheapplianceshortlyafter
the boiling point is reached. For the proper functioning of the automatic shut-off device, it is necessary that the lid
be completely closed. NOTE: The automatic shut-off switch is located at the base of the Hot Pot. Upon automatic
shut-off you may see a few drops of water on the base unit. This condensate will not impair the operation of the
Hot Pot, nor its safety.
•Unwindthepowercordtothedesiredlengthbeforepluggingthecordintoapoweredoutlet(seefollowing
instructions for short cord appliances.)
•Whenthisappliancehasapolarizedplug(onebladeiswiderthantheother),asasafetyfeature,thisplugwillt
in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician. Do not attempt to defeat this safety feature.
•Ashortpowersupplycordisprovidedwiththisappliancetoreducetheriskresultingfromitsbecomingentangled
in or tripping over a longer cord and causing the Hot Pot to overturn, discharging its hot contents. While EdgeCraft
does not recommend it, extension cords are available and may be used if care is exercised in their use. If an
extension cord is used the marked electrical rating of the extension cord should be at least as high as the electrical
rating of the Hot Pot; and match the configuration of the plug. The longer cord should be arranged so that it will not
drape over the countertop or tabletop where it can be pulled on by children or tripped over.
•Plugbaseunitintoa110-120volt,ACoutlet.
•PushdowntheHotPotpowerswitch(seephoto)totheonposition.Theswitchwillilluminatetoindicatethe
power is on.
•TheHotPotswitchesoffautomaticallyafewsecondsaftertheboilingpointisreached.
•ThetimerequiredfortheHotPottoautomaticallyswitchoffaftertheboilingpointisreachedwillvarydepending
on the amount of water in the Hot Pot. It will switch off faster if filled to its “maximum” level than if filled to only a
minimum level.
•Ifonlywarmwaterisdesired,simplyinterrupttheheatingprocedureatanytimebyswitchingthepowerswitchoff.
•TheHotPotcanbeliftedeasilyfromthebaseforpouringorserving.Thepouringspouthasbeenspeciallydesigned
to easily pour even small amounts of water.
•ReplacetheHotPotonthebaseunitwhennished
pouring. The power switch must be pushed down to
the on position if you wish to restart the heating of
the water.
•Alwayscheckthewaterlevelbeforeturningthepower
switch on. Make certain there is at least one cup of
water in Hot Pot before turning switch on.
•Avoidspillingwateronthebaseunit.Intheeventthat
the base unit becomes wet, proceed as follows:
- disconnect the power cord from the power outlet.
- invert base and shake out water.
- dry the base unit with a dry absorbent cloth.
- place the Hot Pot on the base and re-insert the
power cord into the power outlet.
water
level
gauge
illuminated
on/off switch