• Unwindthepowercordtothedesiredlengthbeforepluggingthecordintoapoweredoutlet.(Seefollowing
instructions for short cord appliances.)
• Whenthisappliancehasapolarizedplug(onebladeiswiderthantheother),asasafetyfeature,thisplug
will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it
still does not fit, contact a qualified electrician. Do not attempt to defeat this safety feature.
• Ashortpowersupplycordisprovidedwiththisappliancetoreducetheriskresultingfromitsbecoming
entangled in or tripping over a longer cord and causing the Hot Pot to overturn, discharging its hot contents.
While EdgeCraft does not recommend it, extension cords are available and may be used if care is exercised
in their use. If an extension cord is used the marked electrical rating of the extension cord should be at
least as high as the electrical rating of the Hot Pot; and match the configuration of the plug. The longer
cord should be arranged so that it will not drape over the countertop or tabletop where it can be pulled on
by children or tripped over.
• Plugbaseunitintoa110-120volt,ACoutlet.
• PushdowntheHotPotpowerswitch(seephoto)totheonposition.Theswitchwillilluminatetoindicate
the power is on.
• TheHotPotswitchesoffautomaticallyafewsecondsaftertheboilingpointisreached.
• ThetimerequiredfortheHotPottoautomaticallyswitchoffaftertheboilingpointisreachedwillvary
depending on the amount of water in the Hot Pot. It will switch off faster if filled to its “maximum” level
than if filled to only a minimum level.
• Ifonlywarmwaterisdesired,simplyinterrupttheheating
procedure at any time by switching the power switch off.
• TheHotPotcanbeliftedeasilyfromthebaseforpouringor
serving. The pouring spout has been specially designed to
easily pour even small amounts of water.
• ReplacetheHotPotonthebaseunitwhennishedpouring.
The power switch must be pushed down to the on position if
you wish to restart the heating of the water.
• Alwayscheckthewaterlevelbeforeturningthepowerswitch
on. Make certain there is at least one cup of water in Hot Pot
before turning switch on.
• Avoidspillingwateronthebaseunit.Intheeventthatthebase
unitbecomeswet,proceedasfollows:
- disconnect the power cord from the power outlet.
- invert base and shake out water.
- dry the base unit with a dry absorbent cloth.
- place the Hot Pot on the base and re-insert the
power cord into the power outlet. 4
illuminated
on/off switch
water level
gauge