Chipolino BED GUARD User manual

This product branded with has been produced in
compliance with requirements of Standard BS 7972 „Safety requirements
and test methods for children’s bed guards for domestic use”, as well as
Consumer Protection Law from national legislation.
ATTENTION! KEEP THIS MANUAL FOR FUTURE REFERENCE!
ИНСТРУКЦИЯ ЗА УПОТРЕБА НА
ПРЕГРАДА ЗА ЛЕГЛО

1
TO ENSURE SAFE USAGE OF THIS PRODUCT, FOLLOW WARNINGS,
INSTRUCTIONS AND RECOMMENDATIONS GIVEN IN THIS USER’S MANUAL!
ATTENTION! WARNINGS!
• DO NOT USE THIS BEDGUARD IF YOUR CHILD IS AGED LESS THAN 18 MONTHS OR OVER 5
YEARS! USE THE BEDGUARD ONLY IF THE CHILD IS ABLE TO GET UP AND GET OUT OF THE
BED UNAIDED!
• THIS BED GUARD DOES NOT SUBSTITUTE BABY’S COT AND DOES NOT PROVIDE THE
SAME LEVEL OF SAFETY.
• USETHEBEDGUARDONLYFORBEDWITHMAXIMUMTHICKNESSOFMATTRESS25сm.
• AFTER INSTALLATION, MAKE SURE THAT BEDGUARD IS PROPERLY AND STABLE FIXED.
• DO NOT USE THE BEDGUARD IF THE FIXING DEVICES ARE NOT STRONGLY FIXED TO BED
AND/OR TO MATTRESS AND BED GUARD.
• REGULARLY CHECK FOR BROKEN, WORN OUT PARTS OR TORN TEXTILE AS WELL AS
GOOD WORKING ORDER OF ALL LOCKING MECHANISMS.
• DO NOTUSETHEBEDGUARDONSURFACESTHATAREHIGHERTHAN60сm,MEASURED
FROM THE GROUND.
• DO NOT USE SPARE PARTS THAT ARE NOT APPROVED BY THE PRODUCER! PRODUCER
DOES NOT TAKE ANY RESPONSIBILITY FOR SAFETY IN CASE YOU USED SPARE PARTS
DIFFERENT THAN ORIGINAL ONES FOR APPROVED TYPE OR RECOMMENDED BY HIM.
• DO NOT USE BED GUARD FOR ADULTS OR OUT OF HOME!
• WHEN BED GUARD IS INSTALLED AT THE BED, MAKE SURE THAT THERE IS A DISTANCE AT
LEAST 25 cm BETWEEN END OF THE BED AND CORRESPONDING END OF THE BED
GUARD!
• DO NOTallowpresenceofchildrenagedlessthan3yearsbeforeyouassembledtheproductcom
 pletelytoavoidaccessofsmallparts!
• Keepnylonpackagesawayfromchildrentoavoidsuffocation!
• Itisintendedtoprotectchildrenagedfrom18monthsupto5yearsfromfallingofthebed.
• Bed guard is suitable for:
 -bedwithsize:maximumheight60сmandlengthbiggerthan140сm.
 -mattresswithsizes:Width-76-160сm;Thickness–10-25cm,Length–160-200cm.
MAIN FEATURES OF PRODUCT

2
MAIN PARTS
ASSEMBLY AND FUNCTIONS
ASSEMBLY
Please, make sure that the below described parts are available:
Carry bag Textile part
tube 1 (2 pcs) tube 2 (2 pcs)
left (L) and right (R)
holders
L
R
Assembly,foldingandunfoldingaregiveninillustrationsfrom1upto7.Payattentiontodescriptions
belowtogetherwithillustrationswiththesamenumber.
1 – UNFOLDING OF HOLDERS (L and R).
2 – ASSEMBLY OF TUBES 1.
Threadtubes1throughthetextilepartandjointhemonetoanother.
3 – ASSEMBLY OF TUBES 2
Pressbuttonsatbothsidesandplasticpartleft.Assembletubes2totubes1untilthepinsjumpoutof
theholesandx.
Note:Todisassembledothesameactionsinoppositeway.
CAUTION!Followexactlyinstructions,assemblyandusagesequencefromgiveninthismanualtext
and illustrations.
CAUTION! CHECK CAREFULLY THE FIXING SECURITY AFTER EACH OPERATION!
CAUTION!Fixingofanypositioninmostofthecasesisaccompaniedwithclicksound.
CAUTION!Keepyourngersawaytoavoidentrapmentduringeachoperation!

3
4. INSTLLATION OF BED GUARD TO BED
4-1–Pulltheholders(J);
4-2–Slidetheholders(J)underthemattress;
4-3 – CAUTION! TO AVOID SUFFOCATION RISK DURING POSITIONING OF THE BED GUARD,
THEREMUSTBEADISTANCEATLEAST25cmBETWEENBOTHENDSOFTHEBEDGUARDAND
BOTH ENDINGS OF THE BED.
4-4–Threadthebelts(H)underthemattressattheothersideofthebed;
4-5–Tightenthebelts(H)sothatbothcircles(I)totwelltosideofthemattress.
4-6–Puttheexcessbeltsunderthemattress.
4-7–CAUTION! AFTER INSTALLATION, CHECK IF THE BED GUARD IS STABLE AND SECURELY
FIXED TO THE BED!
5 – Т- DEVICE
Thisdeviceisusedwhenthebaseofthebedismadeofwoodslats.
BeforeinstallationТ-device,youhavetorotateitsbarat90°.
6 – STOWING THE BED GUARD TO THE BED
Toreleasethebedguard(L),presssimultaneouslybothlevers(K) of the holders. Rotate the bed guard
(L)downwardsandmakesureitisxedinthisposition.
7– LIFTING THE BED GUARD
Release the locked bed guard (L). Rotate the bed guard (L) upwards until you hear a click sound and
both levers (K)x.
FUNCTIONS
“click”
pin
tube 1
pin
“click”
1
2
L R
3

4
4-1
4-4
4-5
4-3
4-2
“click”

5
“click”
“click”
4-6
5
6
7
4-6

6
CARE AND MAINTENANCE
• Donotpushtherailsmechanismstronglytoavoiddamages.
• Cleanthefabrics,plasticpartsandmetalpartswithdampcottonclothorspongeandmildsoap.
• Do not use abrasive, bleach or other aggressive detergents.
• Alwaysaftercleaningleavethebedguardfullydryandafterthatusethemorstorethem.Itmay
 appearmoldifyoukeepthemmoist.
• Always store your product  indoors. Do not expose to direct environment inuence - sun, rain,
 moistureandhightemperatureintervals.
• Donotplaceobjectsinorovertheproducttoavoiddamagesoftheframeand/oritstextileparts.
• Please,contactyourauthorizeddealerforproblemsconnectedwiththeuseorrepairofthisproduct.
Materials used:plastic,textile,metal.
KORAIL021xxx

1 Golyamokonarsko shosse, PLOVDIV, BULGARIA
www.chipolino.com