chiptuning-direct Pumpe-duse User manual

Digital Pumpe-düse Power Chip
Installation guide
Version: 02-06-2009

Digital Pumpe-düse Power Chip - Installation Guide
Chiptuning Direct ApS • www.chiptuning-direct.com • [e-mail] Page 2
Important!
Installation of the Digital Pumpe-düse Power Chip module is at your own risk. Furthermore,
Chiptuning Direct ApS accepts no responsibility for defects/damages due to faulty installation or
adjustment of the power chip.
If you have any doubt in connection with installation or daily use we strongly recommend you to
contact a specialist or send an E-mail to our support department [email protected]
Follow the instructions carefully! If you don’t you can potentially influence the operational reliability
of the car. Do not make any changes to the supplied cable kit: The cables are optimised in relation
to impedance and resistance. Therefore the cables are not to be extended, shortened or modified in
any other way.
General installation instructions
1. Turn off the engine
2. Look closely at the supplied cables and determine which cables are to be connected to what. In
the following the correct installation is explained step by step. At this moment the Power Chip is not
to be connected to the cable kit.
Connection of cable kit
Remove the engine shield.
Red
Black

Digital Pumpe-düse Power Chip - Installation Guide
Chiptuning Direct ApS • www.chiptuning-direct.com • [e-mail] Page 3
When you have removed the engine shield you see a round plug by the cylinder head.
In transverse-engined cars (eg. VW Bora and Golf) the plug is placed to the left side of the engine
block - looking in the driving direction.
In longitudinal-engined cars (eg. Audi A4 and A6) the plug is placed at the front of the engine block
- looking in the driving direction.
Release the connection to the cylinder head and mount the cable set.
Round plug, engine
longitudinally
Round plug. engine
transversely
ENGINE

Digital Pumpe-düse Power Chip - Installation Guide
Chiptuning Direct ApS • www.chiptuning-direct.com • [e-mail] Page 4
NOTICE!
Make sure that you have heard the plug »click« into place. Otherwise you may risk that the chip
does not function properly.
Now, attach the cable kit’s red cable to the positive battery terminaland the black cable to the grounding.
It is very important that the the Power Chip is mounted in due distance of the engine and without
risk of impact of water or vibrations!
At last, check one more time that all connections are properly connected. Remount all removed
shields and your Digital Power Chip is ready for use.
Calibration of the Power Chip
Bring the vehicle on operating temperature. (Approx 90C / 5 minutes).
Switch off the ignition And install the Power Chip again.
The calibration phase needs at least 45sec in th etick-over. As long as the LED’s (red and yellow)
flash alternately do not press the operatior.
The module calibrates itself automatically. The calibration phase ends if the red LED lights up con-
stantly and the yellow LED flashes.
Switch off the ignition. Now the system is ready for the test run.
Test and adjustment of the Power Chip
The digital construction of the power chip allows you to choose the program which is best suited to
your car model, engine capabilities and individual preferences.
ROUND PLUG

Digital Pumpe-düse Power Chip - Installation Guide
Chiptuning Direct ApS • www.chiptuning-direct.com • [e-mail] Page 5
Unplug the box from the cable lead. In one end of the box there is a transparent lid, remove this.
Adjust the Power Chip by moving the jumper. When delivered the jumper is in position »T«, as il-
lustrated below:
Once the power chip is installed, check the correctness of all connections. Then the engine can be
started. The program can be changed, if necessary. In some cars more powerful programs cause the
exhaust smoke to appear. This is related to the error range of the sensor signals. To eliminate smoke
a weaker program should be set.
In case of problems
If during the installation you are facing any problems or are in doubt you are always welcome to
contact our support department by e-mail at [email protected] (our support can be con-
tacted by E-mail only).
Have fun with your new Digital Pumpe-düse Power Chip in your daily driving!
Best regards
Chiptuning Direct ApS