Choice 109CARTBS2 User manual

Plastic
Utility/Bussing Carts
Assembly Instructions
07/2023
Parts
Included:
(2) Handles
(2-3) Shelves
(4-8) Posts
(2) Casters w/ Brake
(2) Casters
(4-6) Side Panels
A
B
C
D
E
F
Before Assembly:
Lay out all pieces and make sure
none are damaged before pung
cart together. Unwrap any pieces
that are wrapped.
Tools Needed:
Rubber Mallet
D E
A
B
C
F
1
2
Assembly
1. Take base/boom shelf (this will be in the boom of the box) and
place the four metal posts on each of the corners.
Use a mallet to secure into place.
Note:The shelf will have a lower lip on one side. Make sure that it
is facing out and that the rest of shelves align (the top shelf has the
Choice logo on the lower lip side).
2. Set the middle shelf on top of the four posts. Use mallet to secure
into place. Place four metal posts on each of the corners of the
middle shelf. Use mallet to secure into place.
Note: Skip this step if you are building a 2-shelf unit.
Note: Side panels can be installed along with each shelf.
109CARTBS2 109CARTLG2 109CARTBLG 109CARTBUS 109BCRT2PLBK109BCRT3PLBK
(109BCRT2PLBK/109BCRT3PLBK Only)

Assembly
3
4
5
6
3. Set the top shelf on top of the four posts. Use mallet to secure into place.
4. Turn cart upside down so that the top shelf is facing the ground.
You will have two sets of casters, two with brakes and two without
brakes. The casters with brakes will go on the same side (the two posts
closest to each other) and the casters without brakes will go on the
opposite side of these.
5. To install the casters, push them into the slots on the boom corners
of the cart. Make sure to fully secure into place (you may need a mallet
for this as well).
6. Flip cart over. Aach the handles to each side of the cart, above each
set of casters.
7. Finally, make sure everything is secure and ghtened into place before
using. Assembly complete.
Note: To stop cart from moving, use the braking casters by ipping
metal piece on caster to put cart in place.