Cimetrics B2000 User manual
1
1
Your B2000
(Modbus/TCP to
Modbus/RTU router)
Router must be
configured before use!
(NOTE: An Ethernet HUB or crossover cable is required)
Access the B2000 configuration screen using your browser. Here is an explanation of
how to do this:
Connect the B2000 Ethernet connector to an Ethernet hub, and run another Ethernet cable from that hub to
your laptop or PC. Make sure that the laptop or PC is the
only
other unit in this small LAN. NOTE: If you do
not have a hub, you can use a "crossover cable" to connect between the B2000 and your laptop.
Set your PC's IP address to
192.168.88.90
with a subnet mask of
255.255.255.252
.
2
2
Open your browser andenterthe followingURL: http://192.168.88.89
You will be prompted to login:
User=admin password=admin
The Cimetrics default password is a secure mixture of letters and numbers but also can be
remembered because of the relationships of these keys on your computer keyboard.
From within the browser interface you can change all settings in the entry fields to configure your
router
For improved access security, you should change your password from the default values.
Make
sure you SAVE your new password!
When you press "Activate Configuration" and “confirm”
then the configuration process is completed.
Now disconnect your laptop and connect the B2000 into your BACnet networks.
Note! We strongly recommend that the power be recycled on the unit at least once every six
months
Table of contents
Other Cimetrics Network Router manuals
